Casio Exilim Ex Fh100 Users Guide

							101Advanced Settings
Procedure
[r] (REC) * [MENU] * REC Tab * Digital Zoom
Select “On” when you want to use digital zoom (page 47).
• Digital zoom is disabled while shooting with the following feature.
– High speed movie recording
– “RAW+” image size
Procedure
[r] (REC) * [MENU] * REC Tab * L/R Key
You can assign one of the seven functions listed below to the [4] and [6] keys.
Turning Digital Zoom On or Off (Digital Zoom)
Assigning Functions to the [4] and [6] Keys (L/R Key)
Setting[4]/[6] key operation
Q*´*)Selecting a Focus Mode (page 91)
•W (Manual Focus) cannot be selected.
Metering Changes the Metering Mode (page 106)
Self-timer Sets the self-timer time (page 94)
Face Detection Turns face detection on and off (page 98)
ISO Specifying ISO Sensitivity (page 41)
White Balance Adjusting White Balance (page 42)
EV Shift Correcting Image Brightness (page 43)
Off Cancels [4] and [6] key assignments
Downloaded From camera-usermanual.com Casio Manuals 
						

							102Advanced Settings
Procedure
[r] (REC) * [MENU] * REC Tab * Quick Shutter
When Quick Shutter is turned on, you can press the shutter button all the way without 
waiting for Auto Focus. This will record the image using a high speed focus operation 
that is much faster than Auto Focus.
NOTE
• At relatively high zoom factors, Quick Shutter will stop working and the camera will 
switch over to standard Auto Focus.
• The Quick Shutter setting is enabled for the second and subsequent images of a 
Normal Speed CS group.
Procedure
[r] (REC) * [MENU] * REC Tab * Grid
The on-screen grid can be displayed on the REC mode 
monitor screen for easy vertical and horizontal alignment 
when composing images.
Shooting with Quick Shutter (Quick Shutter)
OnTurns on Quick Shutter
• Some images may be out of focus when Quick Shutter is used.
OffTurns off Quick Shutter so focus is performed using normal Auto Focus 
before the image is recorded.
• If you fully press the shutter button while Quick Shutter is turned off, 
images will continue to be shot without focusing.
• Whenever possible, take a little extra time to half-press the shutter 
button in order to ensure proper focus.
Displaying the On-screen Grid (Grid)
Downloaded From camera-usermanual.com Casio Manuals 
						

							103Advanced Settings
Procedure
[r] (REC) * [MENU] * REC Tab * Review
While Review is turned on, the camera will display a image for about one second 
immediately after you press the shutter button to record it.
• Image review is available only when shooting single images. It does not work with 
continuous shutter.
Procedure
[r] (REC) * [MENU] * REC Tab * Icon Help
While Icon Help is turned on, a textual description will appear on the display for 
certain icons when you switch between REC functions.
Functions Supported by Icon Help
• Exposure mode
• Available options for the “L/R Key” setting
• Exposure warning when shutter button is half-pressed
Turning on Image Review (Review)
Using Icon Help (Icon Help)
Downloaded From camera-usermanual.com Casio Manuals 
						

							104Advanced Settings
Procedure
[r] (REC) * [MENU] * REC Tab * Memory
This setting lets you specify which camera settings should be remembered by the 
camera when it is turned off, and restored the next time the camera is turned on. To 
have the camera remember a setting, you should enable the setting’s memory. Any 
setting whose memory is disabled will be reset to its initial default any time the 
camera is turned off.
*Optical zoom setting only.
Configuring Power On Default Settings (Memory)
SettingDisabled (Initial Default Setting)Enabled
Flash Auto
Setting at 
power off FocusQ
 (Auto Focus)
ISO Auto
White Balance Auto WB
EV Shift 0.0
AF Area Spot
Metering Multi
CS High Speed CS
Self-timer Off
Flash Intensity 0
Digital Zoom On
MF Position Position before manual focus was selected.
Zoom Position
*Full wide
Downloaded From camera-usermanual.com Casio Manuals 
						

							105Advanced Settings
Procedure
[r] (REC) * [MENU] * Quality Tab * T Quality (Snapshot)
• The “Fine” setting helps to bring out details when shooting dense tree branches or 
leaves, a complex pattern, etc.
• Memory capacity (the number of images you can record) will be affected by the 
quality settings you configure (page 194).
Procedure
[r] (REC) * [MENU] * Quality Tab * » Quality (Movie)
This setting can be used to specify HD or STD as the image quality for movie 
recording when HD/STD is selected as the movie mode.
Image Quality Settings (Quality)
Specifying Snapshot Image Quality (T Quality (Snapshot))
FineGives image quality priority
NormalNormal
EconomyGives the number of images priority
Movie Image Quality Settings (» Quality (Movie))
HDSelect this setting record high-definition (HD) movies (page 62). The aspect 
ratio of movies recorded with this setting is 16:9.
STDUse this setting for standard movie recording. Recording with this setting is 
performed using an aspect ratio of 4:3, an image size of 640x480 pixels, 
and a frame rate of 30 frames per second. Image quality and image size 
settings cannot be changed.
Downloaded From camera-usermanual.com Casio Manuals 
						

							106Advanced Settings
Procedure
[r] (REC) * [MENU] * Quality Tab * HS » Speed
See page 62 for details.
Procedure
[r] (REC) * [MENU] * Quality Tab * MeteringThe metering mode determines what part of the subject is metered for exposure.
Procedure
[r] (REC) * [MENU] * Quality Tab * Lighting
You can use this setting to optimize the balance between bright areas and dark areas 
when shooting images.
Setting the High Speed Movie Frame Rate (HS » Speed)
Specifying the Metering Mode (Metering)
 MultiMulti-pattern metering divides the image into sections and measures 
the light in each section for a balanced exposure reading. This type 
of metering provides error-free exposure settings for a wide range of 
shooting conditions.
 Center 
WeightedCenter weighted metering concentrates on the center of the focus 
area to measure light. This type of metering is best when you want 
some level of control over contrast.
 SpotSpot metering takes readings at a very small area. Use this metering 
method when you want exposure to be set according to the 
brightness of a particular subject, without being affected by 
surrounding conditions.
Optimizing Image Brightness (Lighting)
OnPerforms brightness correction.
OffDoes not perform brightness correction.
B
N
˜
Downloaded From camera-usermanual.com Casio Manuals 
						

							107Advanced Settings
Procedure
[r] (REC) * [MENU] * Quality Tab * Flash Intensity
You can specify flash intensity to one of five levels from +2 (brightest flash) to –2 
(least bright flash).
• Flash intensity may not change when the subject is too far away or too close.
Procedure
[r] (REC) * [MENU] * Quality Tab * Color Filter
Settings: Off, B/W, Sepia, Red, Green, Blue, Yellow, Pink, and Purple
Procedure
[r] (REC) * [MENU] * Quality Tab * Sharpness
You can specify one of five sharpness settings from +2 (sharpest) to –2 (least sharp).
Procedure
[r] (REC) * [MENU] * Quality Tab * Saturation
You can specify one of five saturation settings from +2 (most saturated) to –2 (least 
saturated).
Procedure
[r] (REC) * [MENU] * Quality Tab * Contrast
You can specify one of five contrast settings from +2 (most contrast between light and 
dark) to –2 (least contrast between light and dark).
Specifying Flash Intensity (Flash Intensity)
Using Built-in Color Filters (Color Filter)
Controlling Image Sharpness (Sharpness)
Controlling Color Saturation (Saturation)
Adjusting Image Contrast (Contrast)
Downloaded From camera-usermanual.com Casio Manuals 
						

							108Viewing Snapshots and Movies
Viewing Snapshots and Movies
See page 28 for the procedure for viewing snapshots.
1.Press [p] (PLAY) and then use [4] and [6] to display the movie you 
want to view.
2.Press [SET] to start playback.
Movie Playback Controls
• Playback may not be possible for movies not recorded with this camera.
Viewing Snapshots
Viewing a Movie
Fast forward/fast 
reverse[4] [6] (Playback in progress.)
• Each press of either button increases the speed of the 
fast forward or fast reverse operation.
• To return to normal playback speed, press [2].
Play/pause[SET]
1 frame forward/
back[4] [6] (Playback paused.)
• Holding down either button scrolls continuously.
Volume adjustmentPress [2] and then press [8] [2]
• Volume can be adjusted only while movie playback is in 
progress.
Information display 
on/off[8] (DISP)
ZoomSlide the zoom controller in the direction of z ([).
• You can use [8], [2], [4], and [6] to scroll the zoomed 
image on the monitor screen. You can zoom a movie 
image up to 4.5 times normal size.
Stop playback[MENU]
Movie icon: »
Image quality Recording time
Downloaded From camera-usermanual.com Casio Manuals 
						

							109Viewing Snapshots and Movies
Each time you perform a continuous shutter (CS) operation, the camera creates a CS 
group that includes all of the images for that particular CS session. You can use the 
following procedure to play back the images in a particular CS group.
1.Press [p] (PLAY) and then use [4] and [6] to display the CS group 
whose images you want to view.
2.About one second after you select a CS group, high speed playback of 
its images will start automatically.
• After playback of a CS Group is complete, the first image of the group will be 
displayed on the monitor screen.
• Pressing [SET] will pause playback. While playback is paused, you can adjust 
the playback speed, specify the playback direction, scroll forward or back, 
zoom images, and delete images.
Viewing Continuous Shutter Images
Number of image files in
the CS group
First image in the CS groupCS group icon
Current image number/number 
of images in the group
CS speed
Playback guide
Downloaded From camera-usermanual.com Casio Manuals 
						

							110Viewing Snapshots and Movies
The following are operations that are supported after you press [SET] to 
start image playback.
NOTE
• Multiple images shot using normal-speed continuous shutter are stored individually 
and are not grouped. This means they can be displayed individually (page 28) but 
not as a CS group.
You can use the following procedures to delete images while playback is in progress 
or paused.
.Deleting a Specific CS Group File
1.While CS image playback is in progress or paused (toggle by pressing 
[SET]), press [2].
This will display the “CS Frame Edit” menu.
2.Use [8] and [2] to select “Delete” and then press [SET].
[4] [6]During playback, changes the playback direction and playback speed.
While playback is paused, scrolls forward or back.
• Playback speed cannot be adjusted while the displayed image is 
zoomed.
[SET]Toggles between pause and play.
Zoom 
controllerZooms the image.
• You can use [8], [2], [4], and [6] to scroll the zoomed image on 
the monitor screen.
• Sliding the zoom controller towards z ([) while an image is not 
zoomed will display a menu of images in the current CS group.
[MENU]Exits CS group playback.
[8] (DISP)Cycles through information display formats.
[2]Displays the “CS Frame Edit” menu.
Deleting Continuous Shutter Images
Downloaded From camera-usermanual.com Casio Manuals