Casio Ex Fh25 Users Guide

61Snapshot Tutorial
13.Press [SET].
• The approximate number of recordable CS images will appear on the monitor screen.
14.Half-press the shutter button.
This will cause the camera to start pre-recording images.• The camera will not emit a shutter sound when you half-press the shutter 
button while Prerecord CS is selected.
• If you release the half-pressed shutter button before pressing it the rest of the  way down, all of the pre-recorded images currently in the buffer will be deleted.
15.When you are...

62Snapshot Tutorial
NOTE
• Note the following when selecting a High Speed CS speed (fps) setting.– Use a higher High Speed CS speed (fps) setting when shooting a fast-moving  subject.
– Use a slower High Speed CS speed (fps)  setting when shooting a slower-moving 
subject.
• Note the following when selecting a High Speed CS maximum number of shots  setting.
– The greater the number of shots, the longer it takes to save them after shooting  is complete.
• Note the following when specifyi ng a Prerecord...

63Snapshot Tutorial
5.Press [SET] to apply the setting.
Select & Save
After continuous shutter shoot ing is finished, the shot images are played back 
at slow speed so you can select the images you want to save. • When shooting with Prerecord CS, the first image saved when you press the 
shutter all the way is indicated by an “ S” mark so you can tell where the 
continuous shutter operation started.
1While the shot images are playing back and an image 
appears that you want to save, press the shutter...

64Snapshot Tutorial
• If there is not enough available capacity on the memory card, you may not be able to record the number of CS images indicated on the monitor screen. Make sure 
your memory card has sufficient remain ing capacity before shooting with using 
continuous shutter.
• With continuous shutter, exposure and focus for the first image are applied for  successive images as well.
• When using a continuous shutter mode, k eep the camera still until shooting is 
finished.
• In the Continuous...

65Recording Movies
Recording Movies
1.Set the mode dial to ³ (HD/STD).
2.Press [8].
3.Use [ 8] and [ 2] to select the second control panel option from the top 
(HD/STD switching).
4.Use [ 4] and [ 6] to select “STD” (Standard), and then press [SET].
• Recording is performed with an aspect ratio of 4:3, an image size of 640x480 
pixels, and a frame rate of 30 frames per second (STD Movie). Image size 
setting cannot be changed.
5.Press the shutter button.
This will start recording and display  Y on the...

66Recording Movies
Your camera has a built-in microphone that can be used to record audio (monaural) 
during movie recording.
. Recording Precautions
The camera also records audio. Note the following points 
when shooting a movie.
– Take care that the microphone  is not blocked by your 
fingers, etc.
– Good audio recording results are not possible when the  camera is too far away from what you are trying to record.
– Operating camera buttons while shooti ng can cause button noise to be picked 
up in the...

67Recording Movies
• The effects of camera movement in an image become more pronounced when you shoot close up or with a large zoom factor . Because of this, use of a tripod is 
recommended under these conditions.
• Face Detection is disabl ed during movie recording.
• The exposure mode changes to 
t (Auto) automatically whenever you shoot a 
movie with the “ STD” or “ HD” movie mode (pages 65, 67).
• The aperture, shutter speed, and ISO sensitiv ity settings (M mode only) configured 
with the snapshot...

68Recording Movies
This camera supports recording of high speed movies at a maximum speed of 
1000 fps. The aspect ratio of movies recorded with this mode depends on the frame 
rate (recording speed). • When shooting with the “ HS” movie mode at a frame rate setting of “30-120 fps” or 
“30-240 fps”, audio is recorded only while the  camera is shooting at 30 fps. Audio is 
not recorded at any other frame rates.
1.Set the mode dial to  © (HS).
2.Press [ 8].
3.Use [ 8] and [ 2] to select the second control...

69Recording Movies
NOTE
• The higher the frame rate (speed), the more lighting is required when shooting. 
When shooting a high speed movie, sh oot in a well-lit environment.
• When recording certain types of movies, the image that appears on the monitor  screen may be smaller than normal. When re cording a high speed movie, there are 
black bands along the top, bottom, left, and right of the screen.
• When recording a high speed movie, light  source flicker can cause horizontal 
bands to appear in the...

70Recording Movies
.To set up the came ra to shoot with Prerecord Movie
1.In the REC mode, set the mode dial to ³ (HD/STD) or ©
 (HS).
Select the movie mode you want to use.
2.Press [ 8].
3.Use [ 8] and [ 2] to select the third control panel option from the 
bottom (Prerecord (Movie)).
4.Use [ 4] and [ 6] to select “Prerecord (M ovie): On” and then press 
[SET].
This causes  ‰ (Prerecord (Movie)) to appear on the monitor screen, indicating 
that the camera is prerecording to its buffer.
To turn off...