Casio EX F1 User Manual

91Advanced Settings
You can use the remote shutter 
release that comes with the camera 
when recording. By mounting the 
camera on a tripod and using the 
remote shutter release, you can 
eliminate the chance of blurred images due to accidental hand movement. The 
shutter button of the remote shutter release operates the same way as the camera’s 
shutter button.
. Connection
1.Turn off the camera.
2.Open the terminal cover and 
connect the remote shutter 
release plug to the USB/AV 
port.
Using the...

92Advanced Settings
Use of a commercially available flash unit makes it possible to obtain a higher level of 
brightness than you get when using the built -in flash alone. An external flash also 
makes it possible to extend the effective range of flash photography.
IMPORTANT!
• Some flash performance may be lost when using a ring flash or other type of unit 
with a long flash time.
• The aperture value and ISO sensitivity avai lable with some flash units may not 
match the values supported by your...

93Advanced Settings
.Using an External Flash Unit
IMPORTANT!
• Always make sure that the external flash unit is turned off before attaching it to or 
detaching it from the camera. Leaving the  flash unit on can cause it to fire 
unexpectedly.
1.Remove the shoe cap.
• Keep the shoe cap in a safe plac e where it will not become lost. 
• Replace the shoe cap when you are not  using the external flash shoe. The 
shoe cap protects the shoe contact from dirt and damage. 
2.Attach the external  flash unit to...

94Advanced Settings
.External Flash Precautions
• After recording an image, check it on the monitor screen. If it is not what you 
expected, use the controls on the external  flash unit to adjust flash intensity, and 
adjust the aperture and ISO sensitivity se ttings on the camera. Note that you 
cannot control external flash unit  intensity using camera settings.
• Close up images often tend to be over exposed. If you are having overexposure 
problems, try adjusting the aperture and IS O sensitivity...

95Advanced Settings
NOTE
• Depending on the angle of the light, the lens hood may not have the desired effect.
• Using the flash with the lens hood attached can cause vignetting (darkening of the 
corners of the image). Remove the lens hood before using the flash.
• Use of a commercially available lens hoo d may cause vignetting (darkening of the 
corners of the image).
This camera supports use of co mmercially available 62mm filters.
NOTE
• Carefully read the user documentation that  comes with filters...

96Viewing Snapshots and Movies
Viewing Snapshots and Movies
See page 21 for the procedure for viewing snapshots.
1.Press [p] (PLAY) and then use [ 4] and [ 6] to display the movie you 
want to view.
2.Press [SET] to start 
playback.
Movie Playback Controls
• Playback may not be possible for movies not recorded with this camera.
Viewing Snapshots
Viewing a Movie
[ 4 ] [ 6] During playback, changes the playba
ck direction and playback speed.
While playback is paused, sc rolls forward or back.
Control...

97Viewing Snapshots and Movies
Each time you perform a continuous shutter (CS) 
operation, the camera creates a CS group that includes 
all of the images for that particular CS session. You can 
use the following procedure to  play back the images in a 
particular CS group.
1.Press [p] (PLAY) and then use [4] and [6] 
to display the CS gr oup whose images you 
want to view.
2.Press [SET] to start playback the images in 
the CS group.
This will play back the images in the CS group you 
selected.
Viewing...

98Viewing Snapshots and Movies
Playback Controls
[4 ] [ 6] During playback, changes the pl
ayback direction and playback 
speed.
While playback is paused, sc rolls forward or back.
Control dialDuring playback, changes the pl
ayback direction and playback 
speed.
While playback is paused, sc rolls forward or back.
[SET]Toggles between pause and play.
[DISP]Cycles through information display formats.
Zoom 
controllerZooms the image.
• You can use [ 8], [ 2], [ 4], and [ 6] to scroll the zoomed image 
on...

99Viewing Snapshots and Movies
You can use the following procedures to delete images while playback is in progress 
or paused.
. Deleting a Specific CS Group File
1.While CS image playback is in progress or paused, press [2].
2.Use [4] and [6] to display the image you want to delete.
3.Use [8] and [2] to select “Delete” and then press [SET].
• To delete other files, repeat steps 2 and 3.
• To exit the delete operation, press [MENU].
.Deleting All Files in a CS Group
1.While CS image playback is in...

100Viewing Snapshots and Movies
.Dividing Up All CS Groups
1.While a CS group folder is displayed, press [MENU].
2.Use [4] and [6] to select “PLAY”.
3.Use [8] and [2] to select “Divide Gr oup” and then press [6].
4.Use [8] and [2] to select “Divide All Gr oups” and then press [SET].
5.Use [8] and [2] to select “Yes”, and then press [SET].
• Once a CS group is divided, it cannot be regrouped.
Use the following procedure to copy an image in a CS group to a location outside of 
the group.
1.While a CS...