Canon printer MAXIFY MB5020 User Manual

1660Cause
The ink tank is not installed.
Action
Install the ink tank.1051 

1688Cause
The ink has run out.
Action
Replace the ink tank and close the front cover.
Printing under the current condition may damage the machine.
If you want to continue printing in this condition, you need to release the function for detecting the
remaining ink level. Press and hold the machine's  Stop button for at least 5 seconds, and then release it.
With this operation, releasing the function for detecting the remaining ink level is memorized. Please be
advised that Canon shall not be liable...

1700Cause
The ink absorber is almost full.
Action Tap  OK on the touch screen to continue printing. Contact the service center.1053 

1701Cause
The ink absorber is almost full.
Action Tap  OK on the touch screen to continue printing. Contact the service center.1054 

1754Cause
The ink tank is not installed properly.
Action Open the front cover.
Then push the ink tank.
After installing the ink tank properly, close the front cover.
If the problem is not resolved, contact the service center.
Important
•
The ink tank that was once installed cannot be removed until the ink runs out.
1055 

1755Cause
The ink has run out.
Action
To maintain both machine and print quality, the machine cannot continue printing under the ink out condition.
Cancel printing and replace the ink tank before printing again.
Important
•
Do not remove an ink tank until a new one is prepared to be installed.
•
Once you remove an ink tank, the machine will not operate until a new one is installed.
•
Once you remove an ink tank, the machine will not operate even if the removed ink tank is just
reinstalled.
Note
•
Since...

1871Cause
The cassette is not inserted.
Action Insert the cassette.
Note
•
The cassette paper information registration screen is displayed after inserting the cassette. Registerthe cassette paper information according to the paper you loaded in the cassette.
•
If you want to cancel printing, press the machine's  Stop button.
1057 

1890Cause
The protective material for the print head holder or the tape may remain attached to the holder.
Action Open the front cover, then confirm that the protective material or the tape does not remain attached to the
print head holder.
If you find the protective material or the tape remains attached, remove it, then close the front cover.
If the problem is not resolved, contact the service center.
1058 

2001Cause
The device incompatible with the machine is connected.
Action Check the device connected to the USB flash drive port. Printing photos directly is possible with a USB
flash drive.1059 

2002Cause
An unsupported USB hub is connected.
Action If a USB flash drive is connected to the machine through the USB hub, disconnect the hub from the
machine.
Connect a USB flash drive directly to the machine.1060