Canon cinema EOS C300 Mark II PL User Manual

21
You can check the current Wi-Fi network settings using the camera’s [Network Settings] status 
screens.
1
Press an assignable button set to 
[Status].
 For details about using assignable buttons, refer to 
Assignable Buttons in the camera’s Instruction 
Manual.
2
Push the joystick up/down or turn the 
SELECT dial to display the four 
[Network Settings] status screens.
Checking Settings
1
3
7
8
9
6
4
5
11
13
2
10
12
1Network configuration name 
(Infrastructure connections only)
2 Network connection...

23
2
Using Network Functions
After completing the preparations in the previous chapter, you can connect 
the camera via Wi-Fi to any computer or other supported Wi-Fi enabled 
device that has a Web browser and use the network functions. 

24
After establishing a connection between the camera and a Wi-Fi enabled device1, you can start 
the Browser Remote application on the device’s Web browser2. Refer also to the instruction 
manual of the Wi-Fi enabled device used.
1For details about compatible devices, operating systems,  Web browsers, etc. please visit your local Canon 
Web site.
2A Web browser is required that supports JavaScript and is enabled to accept cookies.
1
Set the camera to   mode and open 
the [Browser Remote] submenu.
[ w...

25
Starting Browser Remote
5
Start the Web browser on the device.
6
Enter the camera’s URL.
 Enter the URL from step 2 into the Web browser’s 
address bar.
 If you chose to use a port other than “80”, you can 
specify it by adding “:nnn” at the end of the URL. 
For example “http://192.168.0.80:095”.
7
Enter the user name and password to 
log in.
 Be sure to enter the same user name and 
password you set on the camera (A19). If 
necessary, consult the administrator who 
configured the camera’s settings....

26
Starting Browser Remote
8
Select the language for Browser 
Remote.
 Click/touch [H] (the language selection button) 
and select the desired language from the list. Most 
buttons and controls emulate physical controls on 
the camera and are labeled in English only, 
regardless of the language selected. 

27
In   mode, you can select one of the network configuration profiles you have previously 
configured (up to 4) to connect the camera to the  desired Wi-Fi network. If you just saved a new 
network configuration ( A17), the camera will automatically connect to that Wi-Fi network and 
steps 1 and 2 in the following procedure are not necessary.
Use the following procedure to set the camera in media server mode. After you connect a Wi-Fi 
enabled device to the same Wi-Fi network the camera is connected...

29
3
Troubleshooting 

30
Check this section if you encounter problems connecting to the Wi-Fi network or accessing the 
camera remotely from a Wi-Fi enabled device. If the problem persists, consult a Canon Service 
Center (listed on the back cover of the camera’s Instruction Manual).
Check This First
XAre the wireless router (access point), the camera and the computer or other Wi-Fi 
enabled device all turned on?
X Is the transmitter correctly attached to the camera’s system extension terminal?
X Is the Wi-Fi network working...