Cannon Canon Allinone Mp C545 User Manual

2-6Paper Handling Chapter 2
Print Media Guidelines
Follow these guidelines when selecting or loading print media:
❑Attempting to print on damp, curled, wrinkled, or torn print media can cause 
jams and poor print quality.
❑Use cut-sheet paper only. You cannot use multipart paper.
❑When using graph paper, the lines may not match because the 1/6-inch (4 
mm) line spacing of the printer is slightly less than that of graph paper.
❑If the print density of your page is very high, light paper stock may curl...

Chapter 2 Paper Handling2-7
Paper Handling
Set the paper thickness lever as follows:
1. Open the document tray.
2. If the printer cover does not open easily, slide the document guides outward 
and then open the printer cover.
❑Open the printer cover by grasping the document guides and lifting.
DO NOT TOUCH THE
GUIDE RAILDO NOT TOUCH THE
ROUND SHAFT
DO NOT TOUCH THE 
RIBBON CABLE 

2-8Paper Handling Chapter 2
3. Press the cartridge button  .
❑The cartridge holder moves to the center of the unit.
4. Set the paper thickness lever.
❑Set to the left ( m ) for paper and most other print media.
❑Set to the right (A) for envelopes.
5. Press the cartridge button  .
❑The cartridge holder moves to its home position on the right side of the 
unit. Do not try to manually move or stop the cartridge holder as this may damage the 
MultiPASS.
c
Ink
CartridgeB
C
l-
2
1
C
o
lo
rM
ade  in
Japan
Ink...

Chapter 2 Paper Handling2-9
Paper Handling
6. Close the printer cover.
7. Close the document tray.
Loading Paper
You can stack paper in the multi-purpose tray to feed it automatically into the 
MultiPASS. 
Guidelines
When automatically feeding a stack of paper in the multi-purpose tray, follow 
these guidelines:
❑To avoid paper jams and poor print quality, never try to print on damp, 
curled, wrinkled, or torn paper.
❑Do not try to load paper into the multi-purpose tray beyond the paper limit 
mark ( )...

2-10Paper Handling Chapter 2
❑Do not leave paper stacked in the multi-purpose tray for long periods of time; 
longer sheets of paper may become bent or curled over time. This may cause 
the paper to misfeed or jam.
❑Depending on the density of your printed pages, the ink may need time to dry. 
Within two or three seconds, the ink becomes smudge resistant. After drying 
for several minutes, the ink becomes water resistant.
❑If your printed page contains a large amount of graphics, the ink on the page 
may...

Chapter 2 Paper Handling2-11
Paper Handling
❑Store paper and other media on a flat surface, and leave it in its wrapper until 
you are ready to use it. Store unused paper from opened packs in the original 
packing in a cool, dry location.
❑Store paper at 64.4°–75.2°F (18°–24°C), 40%–60% relative humidity.
Loading Paper in the Multi-Purpose Tray
1. Make sure the paper thickness lever is set to the left m (see page 2-6).
2. Pull the paper rest up until it stops. To avoid paper jams, smearing, and other...

2-12Paper Handling Chapter 2
3. Move the paper guide to the left to match the size of your paper.
4. Prepare a stack of paper by fanning the edge that will feed into the unit first, 
and then tapping the stack on a flat surface to even its edges. 

Chapter 2 Paper Handling2-13
Paper Handling
5. Insert the stack into the multi-purpose tray until it stops, so that the right edge 
of the stack is aligned with the right side of the multi-purpose tray.
❑The multi-purpose tray holds up to 100 sheets of plain paper — 20 lb. (75 
g/m2) paper.
6. Slide the paper guide snugly against the left edge of the stack.
The MultiPASS is now ready to print. Make sure the top of the stack is below the paper limit mark ( ).
n
D 

2-14Paper Handling Chapter 2
Loading Envelopes
You can stack up to 10 envelopes in the multi-purpose tray to feed them 
automatically into the MultiPASS. 
1. Make sure the paper thickness lever is set to the right A (page 2-6). 
2. Arrange the stack of envelopes on a firm, clean surface, and press down firmly 
on the edges to make the folds crisp.
❑Press all the way around the envelopes to remove any curls and expel air 
from inside the envelopes. Also, press firmly on the area that corresponds 
to the...

Chapter 2 Paper Handling2-15
Paper Handling
3. Remove any curling from the envelopes by holding the edge of the envelopes 
diagonally and bending them gently.
4. Make sure the flaps of the envelopes are flat and not curled.
5. Insert the stack of envelopes into the multi-purpose tray until it stops, so that 
the right edge of the stack is aligned with the right side of the multi-purpose 
tray. Then slide the paper guide snugly against the left edge of the stack.
❑Insert the envelopes with the print side...