Candy Cs 115 D User Instructions
Here you can view all the pages of manual Candy Cs 115 D User Instructions. The Candy manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.
Page 11
20 21 EN Use the 2 feet to level the machine with the floor: a)Turn the nut clockwise to release the screw adjuster of the foot. b) Rotate foot to raise or lower it until it stands firmly on the ground. c) Lock the foot in position by turning the nut anti- clockwise until it comes up against the bottom of the machine. Ensure that the knob is on the “OFF” position and the load door is closed Insert the plug. After installation, the appliance must be positioned so that the plug is accessible. A B C...
Page 12
22 23 A B C D E F G H I L M N O P EN CHAPTER 6 CONTROLSDoor handle Door locked indicator light Start button Crease Guard button Wash Temperature button Start Delay button Aquaplus button Pre-wash button Spin Speed button Digital Display Degree of soiling button Timer knob for wash programmes with OFF position Buttons indicator light Detergent drawer K KA AP PI IT TO OL LA A 6 6 OVLÁDACÍ PRVKYDrÏadlo otevfiení dvífiek Kontrolka zamãená dvífika Tlaãítko Start Tlaãítko Pro Zabránûní Pomaãkání Tlaãítko Volba...
Page 13
25 24 A 2 min. B DESCRIPTION OFCONTROLDOOR HANDLE Press the finger-bar inside the door handle to open the doorIMPORTANT: A SPECIAL SAFETY DEVICE PREVENTS THE DOOR FROM OPENING AT THE END OF THE WASH/SPIN CYCLE. AT THE END OF THE SPIN PHASE WAIT UP TO 2 MINUTES BEFORE OPENING THE DOOR.DOOR LOCKED INDICATOR The “Door Locked” indicator light is illuminated when the door is fully closed and the machine is ON. When START is pressed on the machine with the door closed the indicator will flash momentarily...
Page 14
27 26 C START BUTTON Press to start the selected cycle.NOTE: WHEN THE START BUTTON HAS BEEN PRESSED, THE APPLIANCE CAN TAKE FEW SECONDS BEFORE STARTS WORKING.CHANGING THE SETTINGS AFTER THE PROGRAMMES HAS STARTED (PAUSE) Press and hold the “START/PAUSE”button for about 2 seconds, the flashing lights on the options buttons and time remaining indicator will show that the machine has been paused, adjust as required and press the “START/PAUSE”button again to cancel the flashing lights. If you wish to add or...
Page 15
28 D EN The option buttons should be selected before pressing the START button CREASE GUARD BUTTON The Crease Guard function (Not available on COTTON programmes) minimizes creases as much as possible with a uniquely designed anti-crease system that is tailored to specific fabrics. MIXED FABRICS- the water is gradually cooled throughout the final two rinses with no spinning and then a delicate spin assures the maximum relaxation of the fabrics. DELICATE FABRICS– final two rinses with no spinning and then...
Page 16
30 31 E TLAâÍTKO „VOLBA TEPLOTY“ Tato funkce umoÏÀuje prát pfii jakékoliv teplotû, která je niωí jako maximální pfiedpokládaná teplota pro jednotlivé programy. Tisknutím tlaãítka se teplota sniÏuje aÏ do minimální teploty 15°C (studené praní ). Upozornûní: Teplota musí b˘t nastavena pfied zvolením funkce „STUPE≈ ZNEâI·TùNÍ“. TLAâÍTKO „ODLOÎEN¯ START“ Toto tlaãítko umoÏÀuje odloÏit spu‰tûní pracího programu maximálnû o 24 hodin. Pokud si pfiejete odloÏit spu‰tûní programu, postupujte následujícím...
Page 17
32 G EN AQUAPLUS BUTTON By pressing this button you can activate a special new wash cycle in the Colourfast and Mixed Fabrics programs, thanks to the new Sensor Activa System. This option treats with care the fibres of garments and the delicate skin of those who wear them. The load is washed in a much larger quantity of water and this, together with the new combined action of the drum rotation cycles, where water is filled and emptied, will give you garments which have been cleaned and rinsed to...
Page 18
34 H EN PRE-WASH BUTTON This option is particularly useful for heavily soiled loads and can be used only on some programmes as shown in the programmes table. Detergent for this programme should be added to the compartment of the soap drawer labelled “I”(Please refer to Detergent Drawer Section of manual). We recommend you use only 20% of the recommended quantities shown on the detergent pack and fabric conditioner should not be used for this programme. SPIN SPEED BUTTON The spin cycle is very important...
Page 19
36 EN “DIGITAL” DISPLAY The display’s indicator system allows you to be constantly informed about the status of the machine: 1) WASH TEMPERATURE When a programme is selected the relevant indicator will light up to show the maximum possible wash temperature. Selecting a lower temperature using the special button will cause the corresponding indicator to light up. Note: The temperature must be adjusted before selecting DEGREE OF SOILING. 2) DOOR LIGHT Once the START/PAUSE button has been pressed the light...
Page 20
38 M EN 6) PROGRAMME START LIGHT This lights up when the START button has been pressed. 7) DEGREE OF SOILING When a programme is selected the relevant indicator will light up to show the minimum possible degree of soiling. Selecting a greater degree of soiling using the special button will cause the corresponding indicator to light up. Note: The degree of soiling can vary automatically, depending on the temperature selected. “DEGREE OF SOILING” BUTTON By selecting this button (active only on COTTON and...