Bosch WVD 24460 User Manual

							59
Water drainage hose mWarning
Do not bend or pull the water drainage hose. 
Height difference between the placement area and 
drainage point: maximum 100 cm. 
Drainage into a siphon: 
■Secure connection point with 24-40 mm Ø hose 
clip (specialist outlet). 
Drainage into a wash basin: 
Caution                                                                            
The plug must not block the drain of the wash basin. 
■Secure the drainage hose to prevent it from slip-
ping out of the sink. 
■When the water is being pumped out of the 
washer-dryer, check that the water drains away 
quickly enough. 
Aligning the washer-
dryer All four appliance feet must be firmly on the ground. 
The washer-dryer must not wobble. 
Level the washer-dryer with the assistance of the four 
adjustable feet and a spirit level: 
■Loosen the lock nut 1 using the wrench. 
■Adjust the height by rotating the foot 2. 
■Tighten the lock nut 1 against the housing. 
 
						

							60
Connecting the power mCaution 
Connect the washer-dryer only to an alternating current 
via a correctly installed earthed socket. 
The mains voltage must correspond to the voltage 
specification on the washer-dryer (nareplate). 
Connection specifications as well as the required fuses 
are stipulated on the appliance nameplate. 
Ensure that: 
– The mains plug and socket are compatible. 
– The cable cross-section is adequate. 
– The earthing system has been installed correctly. 
The mains cable may be changed (if required) by an 
electrician only. 
Replacement mains cable available from Customer 
Service. 
Do not use multiple plugs/sockets or extension cables. 
In the event that an earth-leakage circuit breaker is to 
be used, only use types marked with the following 
symbol: z
Only this symbol can guarantee compliance with all 
current regulations.
Do not insert/pull out the mains plug with wet hands. 
Do not pull out the mains plug by tugging the cable. 
 
						

							61
Transport, e. g. 
whenmoving Before transporting the washer-dryer: 
– Turn off the tap. 
– Reduce the water pressure in the water inlet hose 
(refer to page 45). 
– Drain any residual washing solution (refer to page 
44.)
– Disconnect the washer-dryer fror the mains. 
– Dismantle the supply and drainage hose. 
– Install transportation protection devices. 
Having transported the appliance and ensured proper 
installation and connection, allow the Drain [
 
programme to run through before starting the first 
wash programme. 
Transporting the washer-dryer:
Preparing and inserting the 
transport bolts 
■Remove the 4 covers C. 
■Remove the rear cover D and prepare the transport 
bolts. 
■Insert and tighten the transport bolts.
D
C
 
						

							WVD24460GB
0411 en
9000515687
ROBERT BOSCH HAUSGERATE GMBH
..