Bosch WVD 24460 User Manual

51Water not visible in the drum. Not a fault. 
The water lies below the visible part of the drum.
Washing solution is not completely 
drained.Pumped blocked by foreign objects.  Clean the pump (refer to page 44). 
Fluff-producing laundry was 
washed. The water drainage pipe or 
drain hose is blocked.Clean drainage pipe and/or 
drainage hose.
Water runs out from under the 
appliance.Screw fitting of the inlet hose is 
leaking.Tighten the screw-fitting.
Drainage hose is leaking. Replace the drain hose....

52Programme duration changed 
during the programme sequenceNot a fault. 
See also explanations in the chapter Display field, programme 
duration from page 10.
Programme duration reduced Not a fault.
For small amounts of laundry, a reduc tion in time of approx. 30 minutes 
can result, depending on washing/drying programme.
Programme duration extended An overdosage of detergent has 
caused excessive formation of 
froth.An additional rinse cycle and 
spin cycle was run to ensure a good 
rinsing result.
The...

53
Consumption values 
Normal programme Additional 
optionLoad Consumption values** Programme 
duration
Power Water
Cottons 40 °C_ 5 kg 0.46 kWh  51.6 l 1:08 h 
Cottons 60 °C_ 5 kg 1.02 kWh  51.5 l 1:25 h 
Cottons Eco 60 °C Wash Plus
È* 5 kg 0.90 kWh 44.9 l 2:10 h 
Cottons 90 °C
(the hot washing solution is mixed 
with approx.7 litres of cold water 
before being drained)_ 5 kg 1.72 kWh  58.6 l 1:50 h 
Delicate/Silk 30 °C_ 2 kg 0.32 kWh  39 l 0:37 h 
Wool Ï  30 °C_ 2 kg 0.17 kWh  33.1 l 0:41 h 
Easy-Care...

54
Customer service 
Before you call customer service, please check 
whether you can eliminate the fault yourself (see from 
page 47). 
A technician who is called out to give advice will 
charge you, even if the appliance is still under 
guarantee. 
You can find your nearest customer service in the 
enclosed address list. Please provide customer 
service with the product number (E-Nr.) and the 
production number (FD) of the appliance. 
These numbers are shown on the rating plate which 
can be found on...

53
Installation instructions
Installing, connecting and transporting 
Safety instructions mRisk of injury! 
The washer-dryer is heavy. Take care when lifting it. 
Caution                                                                            
Frozen hoses may tear/burst. Do not install the 
washer-dryer in an area where there is a risk of frost or 
outdoors. 
The washer-dryer may be damaged. Do not lift the 
washer-dryer by its projecting parts (e. g. door). 
In addition to the safety information...

54
Useful tools The following tools are helpful: 
– Box wrench A/F 13 for removing the transportation 
bolts. 
– Spirit level for aligning the washer-dryer. 
Dimensions a = 600 mm 
b = 560 mm 
c = 850 mm 
Weight 67 kg 
Installation surface Appliance stability is important so that the washer-dryer 
does not wander during the spin cycles. 
The installation surface must be solid and level. Soft 
floor coverings, e. g. carpets or floor coverings with a 
foam backing are not suitable. 
If the washer-dryer is...

55
Removing the 
transportation 
protection devices mCaution 
The transport bolts must always be removed before 
using the appliance for the first time and must be 
retained for any subsequent transport (e.g. when mov-
ing). 
■Release all screws A using the A/F 13 wrench until 
they can be moved freely.
■Remove the four spacers. They will fall to the floor 
when you tip the machine.
■Insert the covers. 
B
A
D
C
 

56
Built-under or built-in 
appliance installation The appliance must be built under or built in prior to 
connecting the power supply. 
The appliance can be built into or under a kitchen work 
surface. For this purpose, a recess width of 60 cm is 
required. 
■The washer-dryer must only be installed under a 
one-piece worktop that is permanently attached to 
the surrounding cabinets. 
Caution                                                                            
For safety reasons in built-under...

57
Hose and cable 
lengths 
Connection on left side 
Connection on right side 
Other hoses Available from specialist dealers: 
– Extended supply hose (approx. 2.20 m). 
mcmax.100mcmax.100
110cm~
~
100cm~
~
110cm~
~
mcmax.100mcmax.100
150cm~
~
140cm~
~
150cm~
~
 

58
Connecting the water mRisk of electric shock! 
To prevent leaks or water damage, it is essential to
follow the instructions in this chapter! 
Water inlet hose  Caution                                                                            
Operate the washer-dryer with cold drinking water only. 
Do not connect to the mixer tap of an unpressurised 
hot-water apparatus. 
If in doubt, have the appliance connected by a 
specialist. 
Do not use a used inlet hose. Only use the inlet hose 
supplied or...