Bissell 7700 E Manual

11www.bissell.com
Operation
Carpet Cleaning (continued)
7.  Continue to clean entire carpet working in 
one meter by one meter sections.
8.  If machine loses suction, stop spraying and 
check the collection tank level. Empty if 
necessary.
9.  If the machine stops spraying turn off 
wet clean button immediately and check the 
solution tank level. 
NOTE: Never run in wet clean mode when 
the clean water formula tank is dry or 
missing.
When you are finished
1.  Turn off the heater, wet clean, 
and power...

12www.bissell.com
Operation
Hard floor cleaning (continued)
4.  Attach microfibre pad to quick dry hard floor tool by 
attaching to the Velcro strips on the top of the tool.
5.  Attach the quick dry hard floor tool to end of 
the wand.
6.  Place tool directly on the hard floor surface, 
resting on the pad.
7.  Squeeze the spray trigger to moisten the pad 
with cleaning solution. 
Caution: Do not oversaturate.
8.  Move the tool back and forth across the floor 
to clean. Squeeze spray trigger as needed.
9....

13www.bissell.com
Operation
Upholstery cleaning (continued)
2.  Refer to the “Getting Ready to Wet Clean” on 
page 10.
3.  Attach the desired wet cleaning tool to the 
wand or grip.
4.  Clean by pressing the spray trigger to spray 
solution onto the area to be cleaned. Slowly 
move the tool back and forth over the soiled 
surface.  Release the spray trigger to suction 
soiled water.  Continue to clean the area, 
working in small sections, until no more 
dirt can be removed. Suction as needed to 
remove...

Maintenance and care 
Machine storage
Once your cleaning is complete make sure the dirty 
water from the collection tank is emptied. Rinsed out 
and dry before the next use. For wet cleaning, the solu-
tion tank can be left filled and ready to use.  
Note: Store your PROheat All-Rounder in a 
protected dry area. Since this product uses 
water it must not be stored where there is a 
danger of freezing. Freezing will damage the 
internal components and void the warranty.
 WARNING: To reduce the risk of...

Maintenance and care 
Machine care
For best results, a few simple steps can assure 
your machine is well maintained after your 
cleaning is complete.
1.  Press all buttons OFF. Unplug the machine 
and wrap the cord.
2.  After emptying the dirty water from the 
collection tank, rinse it out thoroughly with 
hot water. Remove all inner parts (water 
filtration tower and mode selector) if desired. 
Rinse them and allow to dry before returning 
into tank.
Note: To remove inner parts, turn mode 
selector to...

Troubleshooting 
Reduce Spray or No Spray
Possible Cause  Remedies
1.  Make sure power is on 1.  Press power button if needed
2.  Solution tank may be empty 2.  Fill tank according to directions  
3.  Tank may not be seated properly 3. Turn ON/OFF, heater and wet clean 
      button off. Remove and reseat tank
4.  Hose solution line may be disconnected 4.  Check connection at front of 
    machine
5.  Wet clean is not turned on 5.  Depress wet clean button to turn on
Machine is not suctioning
Possible...

www.bissell.com
BISSELL Consumer Services
If your BISSELL product should require service:
 In the UK, or New Zealand, call BISSELL Consumer Services at the numbers below and we will give 
you the location of a BISSELL Authorized Service Center in your area. For all other countries, contact your local 
in country distributor for questions, service, or repair. 
If you have questions about your warranty or need replacement parts please contact the numbers below.
Or visit the BISSELL website -...

www.bissell.com
Replacement parts - BISSELL PROheat All-Rounder
Below a list of common replacement parts*. While not all of these parts may have come 
with your specific machine, all are available to you for purchase, if desired.
Item Part No.  Part Name
 1  203-7063  Mulit-Surface Floor Tool 
 2  203-7064  Air Powered Floor TurboBrush
 3  203-7073  5 Brush
 4  203-7066  Wand 
 5  203-7067  Adaptor
 6  203-7068  Crevice Tool
 7  203-7069  Upholstery Dusting Brush
 8  203-7070  Carpet Deep Cleaning Tool...

Replacement parts - BISSELL PROheat All-Rounder
 1 2 3 4 5 6 7
 8 91011121314
15161718192021
22232425262728
29303132333435
36 37 38 39 40 41   
       
19www.bissell.com
(Pads not included
ug120-4005_7700_607.indd   19ug120-4005_7700_607.indd   196/28/07   10:06:13 AM6/28/07   10:06:13 AM 

20www.bissell.com
Warranty - BISSELL PROheat All-Rounder
 This warranty gives you specific legal rights, and you may also have other rights which may vary from country 
to country. If you need additional instruction regarding this warranty or have questions regarding what it may 
cover, please contact BISSELL Consumer Services by telephone, or regular post as described below, or 
contact your local in country distributor.
 Limited Two Year Warranty
 Subject to the *EXCEPTIONS AND EXCLUSIONS identified...