Beko Wmd 25100 Ts Users Manual
Have a look at the manual Beko Wmd 25100 Ts Users Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 187 Beko manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Washing Machine User’s Manual WMD 25080 R WMD 25100 R WME 25080 T Стиральная машина Руководство по эксплуатации
3 Dear Customer, We wish that this product, manufactured at modern facilities with total \ quality notions, will deliver you the best performance. In order to guarantee this, please read this instr\ uction manual thoroughly and keep it for your future reference.
4 Technical Features of Your Washing Machine 5 Warning 7 Preparation 9 Program Selection and Starting Machine 13 Care and maintenance 18 Installation 20 Helpful tips on stain removal 23 Before calling service 241 Contents 2 3 4 5 6 7 8
5 Technical Features of Your Washing Machine ModelsWMD 25080 R WMD 25100 R WME 25080 T Maximum dry laundry capacity (kg.) 55 5 Height (cm.) 8484 84 Width (cm.) 6060 60 Depth (cm.) 5454 54 Net Weight (kg.) 6263 62 Electricity (V/Hz.) 230/50230/50 230/50 Total Current (A) 1010 10 Total Power (W) 23002300 2300 Washing -rinsing cycle (cyc/min) 5252 52 Spinning cycle (max cyc/min) 8001000 800There may be changes in the technical features without prior notice in order to enhance product quality. The figures in the manual are schematic and may not represent your actual machine one-to-one. Labelling on your product and ones declared in the docu- ments accompanying product are the values obtained under laboratory conditions with given standards. These values may vary according to usage and environmental conditions. 1
6 1Top Lid 2Front Panel 3Handle 4Kick Plate Cover 5Front door 6Kick Plate 1 2 46 53 Your Washing Machine
7 • This product is designed for home use. • Your washing machine is adjusted to 230V. • If the fuse in your house is less than 16A than have a certified electrician deploy an 16A fuse. • In case of transformer or non-transformer use, ground- ing installation must be performed with a licensed electrician. Any use before grounding is not our respon- sibility. • Never place your machine over a carpet covered floor. Otherwise electrical parts of your machine may over- heat. This may cause malfunction of your machine. • Make sure hot and cold taps are connected correctly. Otherwise your laundry may come out hot and torn . • Please call certified service for a failure of electric plug / cable. • Be careful about your water hoses are not old. Do not use old / torn water hoses. This may cause stain in your laundry . • At first use, washing must be performed at Cotton 90°C program without loading with laundry for getting your machine ready for washing. • Performance of your washing machine depends on the quality of water and hygiene compound used. If low quality and unfitting cleaning material is used the stains will be fixed. Before washing your laundry with stain keep your attention on cleaning the laundry as explained in following pages. • This is period of keeping spare parts for your machine to operate. Because of quality control procedures there might be little amount of water in your machine. This does not have any damage to your machine. • Your machine is programmed for starting operation again when electricity is off and on afterwards. You can not press On / Off button to cancel program. Machine will go on program when electricity is on. To CANCEL the program press >Start/Pause/Cancel< button for three seconds. (See. Cancelling a program) If “Door” led on program progress display is blinking program selection knob is middle position. In this case turn the knob and adjust it again. If the warning contin- ues call authorized service. • After your machine starts operation, if Start/Pause/ Cancel key starts blinking than door is not locked. Open and close the door again begin washing program again. • If the “washing” led on the program progress display is blinking either there is no water or tap is off. Check 2Warning
8 your taps. Turn your machine off and on. If the problem persists unplug your machine, turn off tap water and call authorized service. • If program is started and program selection can not be performed your machine might be in protection mode due to infrastructure problem (voltage, water pressure, etc.) Press and hold the > Start/Pause/Cancel < button for 3 seconds in order to switch machine to factory set- tings. • Most of the warnings resulting in calling an authorized service are due to infrastructure problems. For this rea- son applying to an Authorized Service is recommended.
9 Before starting your machine please beware of below mentioned points: Did you plug the cable? Did you connect draining hose correctly? Did you close front door? Did you open tap water? If you haven’t installed your machine please read to “Installation” section. Sorting the Laundry Sort laundry according to type of fabric, color, level of dirti- ness and allowed washing temperature. Do not wash white laundry together with colored ones. Remove hard parts like belt, wrist button, curtain buttons, etc. or place laundry in a cloth bag. Empty pockets. Zip up and button up. Very tiny laundry like baby clothes may get into inside of drum, midst of bellow, pump filter, hose, etc. in order to prevent this it is advised to place such laundry in a special laundry string bag or large laundry. See practical and useful information section for soiled laundry. Your machine can wash “Ma- chine Wash” or “No-matting” labeled woolen with special woolen program. Delicate laundry with “Do not wash” or “hand wash” label (silk, cashmere, pure wool, etc.) can be washed in the special hand-wash program. Opening front door Pull the handle to open the front door. Your machine’s front door is designed for opening during only machine is not operating. If the led displays “door” than door can open. Loading machine with laundry Fill the machine by unfolding and not squeezing laundry. Place hand-woven garments inside-out to the machine. Make sure there is no laundry jammed between bellow and front-door. Close the loading door by pushing. If loading door is not properly closed machine will not start. Selection of detergent and softener Quantity of the detergent used depends on hardness of water and how soiled laundry is. Recommended values are indicated on the package. If your laundry is low soiled and/ or hardness of water is low use less detergent as indicated on the package. Otherwise it may result in excessive foam. You should use detergent specially designed for automatic washing machines. Avoid using bleach product contain- ing sulfur or chlorine. Place powder detergent and softener in appropriate drawer compartment and close detergent 3 Preparation
10 dispenser. a. Compartment I, powder detergent drawer for pre-wash. b. Compartment II, powder detergent drawer for main wash. c. Softener dispenser d. Siphon Fill the softener as indicated (usually