BEKO WMB 81241 LMB User Manual

21EN
Programme and consumption table
EN2 Auxiliary functions
Programme (°C)
Max. Load (kg)
Water Consumption (l)
Energy Consumption (kWh)
Max. Speed***
Замачивание
Быстрая стирка
Дополнител\fное полоскание
Легкая глажка
Rinse Hold
Pet hair removal
Selectable 
temperature  range °C
\bлопок 908742.40 1600 •••••• 90-Cold
\bлопок 60872 1.70 1600 •••••• 90-Cold
\bлопок 40872 0.95 1600 •••••• 90-Cold
Детская 90872 2.10 1600 *• 90-30
\bлопок Эко 60**865 1.36 1600 •••••• 60-Cold
\bлопок Эко 40872 0.77 1600...

22EN
• : Selectable
* : Automatically selected, no canceling.
** : Energy Label programme (EN 60456)
 *** If maximum spin speed of the machine is lower then this value, you \
can only select 
up to the maximum spin speed.
- : See the programme description for maximum load.
C The auxiliary functions in the table may vary according to the model of your 
machine.
C Water and power consumption may vary subject to the changes in water pressure, 
water hardness and temperature, ambient temperature, type and...

23EN
Auxiliary function selection
Select the desired auxiliary functions 
before starting the programme. 
Furthermore, you may also select or 
cancel auxiliary functions that are suitable 
to the running programme by pressing 
the Start / Pause / Cancel button when 
the machine is operating. For this, the 
machine must be in a step before the 
auxiliary function you are going to select 
or cancel.
Depending on the programme, press a, 
b, c or d buttons to select the desired 
auxiliary function. Symbol of...

24EN
This function helps to remove pet hair 
that remain on your garments more 
effectively.
When you select this function, Prewash 
and Extra Rinse steps are added to the 
normal programme. Thus, washing is 
performed with more water (30%) and the 
pet hair is removed more effectively.
A Never wash your pets in the washing 
machine.
Time display
Remaining time to complete the 
programme appears on the display 
while the programme is running. Tim is 
displayed as “01:30” in hours and minutes 
format.
C...

25EN
2. Start symbol showing the startup of 
the programme will turn on.
3.  Loading door is locked and Door 
Locked symbol appears on the 
display.
4.  The symbol of the step from which 
the programme has started appears 
on the display (Prewash, Main Wash, 
Rinse, Softener and Spin).
Progress of programme
Progress of a running programme is 
indicated on the display with a set of 
symbols.
Relevant symbol appears on the display 
at the beginning of each programme step 
and all symbols remain lit at the...

26EN
C The loading door will not open if the 
water temperature in the machine is 
high or the water level is above the 
door opening.
Child Lock
Use Child Lock function to prevent 
children from tampering with the 
machine. Thus you can avoid any 
changes in a running programme.
C You can switch on and off the 
machine with On / Off button when 
the Child Lock is active. When 
you switch on the machine again, 
programme will resume from where 
it has stopped.
To activate the Child Lock:
Press and hold...

27EN
6 Maintenance and cleaning
Service life of the product extends and 
frequently faced problems decrease if 
cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular 
intervals (every 4-5 washing cycles) 
as shown below in order to prevent 
accumulation of powder detergent in 
time.
1.  Press the dotted point on the siphon 
in the softener compartment and pull 
towards you until the compartment is 
removed from the machine.
C If more than normal amount of water...

28EN
1. Close the taps.
2.  Remove the nuts of the water intake 
hoses to access the filters on the 
water intake valves. Clean them with 
an appropriate brush. If the filters are 
too dirty, take them out by means of 
pliers and clean them.
3.  Take out the filters on the flat ends of 
the water intake hoses together with 
the gaskets and clean thoroughly 
under running water.
4.  Replace the gaskets and filters 
carefully in their places and tighten 
the hose nuts by hand.
Draining remaining water and...

29EN
at the end of the hose. When the 
container is full, block the inlet of 
the hose by replacing the plug. After 
the container is emptied, repeat the 
above procedure to drain the water in 
the machine completely.
c.  When draining of water is finished, 
close the end by the plug again and 
fix the hose in its place.
d.  Turn the pump filter to take it out.
Discharging the water when the product 
does not have an emergency draining 
hose:
a.  Place a large container in front of the 
filter to catch...

30EN
7 Troubleshooting
Programme cannot be started or selected. 
•  Washing machine has switched to self protection mode due to a supply problem 
(line voltage, water pressure, etc.). >>> Press and hold Start / Pause / Cancel 
button for 3 seconds to reset the machine to factory settings. (See "Canceling the 
programme")
Water in the machine.
•  Some water might have remained in the product due to the quality control 
processes in the production. >>> This is not a failure; water is not harmful to...