ATT DEFINITY Communications System Generic 3 For Single-Carrier Cabinets Instructions Manual

9-6 6Issue 1  September 1995  
212-Type Modem Switch Setting
Set the o ption switches for the 212-type modem as follows:
Implement and Administer System 
Data
After the hardware is installed and the system is activate d, the data for system 
and telephone features can be administered. The imp lementation procedures 
are provided in the United States English book, 
D EFI NITY  Communications 
System Generic 3 Implementation
, 555-230-655.
NOTE:
For easier reference, installation steps and test steps are...

Issue 1  September 1995 10-1 
10
Test Telephones and Other 
Equipment
This chapter describes how to test the telephones and other equipment. The 
following tests are included in this chapter:
1. Make test calls (single-cabinet switch)
2. Make test calls (two-cabinet switch)
3. Make test calls (three-cabinet switch)
4. Test the attendant console
5. Test the selector console
6. Test External Ringing
7. Test Queue Warning Indicator
8. Test Integrated Announcement
9. Test Music-on-Hold
10. Test Emergency...

Test Telephones and Other Equipment
10-2Issue 1  September 1995  
and Wire Telephones and Other Equipment, administer it using the procedures 
in the United States English book,
 DEFI NIT Y Com munications System Generic 3 
Implementation, 
555-230-655, and test it using the procedures in this chapter.
The following tests are acceptance tests or sanity tests and they provide some 
assurance the system will p erform p roperly after installation and administration. If 
problems occur or more extensive or...

Make Test Calls (Two-Cabinet Switch)
Issue 1  September 1995 
10-3
Make Test Calls (Two-Cabinet Switch)
Description
To test a two-cabinet switch, you will make the following calls:
nMake a call from a telephone associated with a line port in the Processor 
Port Network (PPN) to a telephone associated with another line port in the 
Processor Port Network (PPN).
nMake a call from a telephone associated with a line port in the Processor 
Port Network (PPN) to a telephone associated with a line port in the...

Test Telephones and Other Equipment
10-4Issue 1  September 1995  
10. Dial the trunk access code. Dial tone is heard .
11. Dial a listed d irectory number (LDN) for a working telephone. Ringback is 
heard through the earpiece of the test telephone.
12. At the called telephone, pick up the receiver. Conversation must be 
satisfactory.
13. Hang up both telephones.
14. Select a working telephone associated with a line port in the Expansion 
Port Network (EPN) as the test telephone and lift the receiver....

Make Test Calls (Three-Cabinet Switch)
Issue 1  September 1995 
10-5
nMake a call from a telephone associated with a line port in the Processor 
Port Network (PPN) to a telephone associated with a line port in the 
Expansion Port Network1 (EPN).
nMake a call from a telephone associated with a line port in the Processor 
Port Network (PPN) to a telephone associated with a line port in the 
Expansion Port Network2 (EPN).
nMake a call from a telephone associated with a line port in the Processor 
Port...

Test Telephones and Other Equipment
10-6Issue 1  September 1995  
6. Dial the extension number of a working telephone associated with a line 
port in Expansion Port Network1 (EPN) . Ringback is heard through the 
earpiece of the test telephone.
7. At the called telephone, pick up the receiver. Conversation must be 
satisfactory.
8. Hang up both telephones.
9. At the test telephone, pick up the receiver.
10. Dial the extension number of a working telephone associated with a line 
port in Expansion Port...

Make Test Calls (Three-Cabinet Switch)
Issue 1  September 1995 
10-7
27. Dial the extension number of a working telephone associated with a line 
port in the Processor Port Network (PPN ). Ri n g back is heard through the 
earpiece of the test telephone.
28. At the called telephone, pick up the receiver. Conversation must be 
satisfactory.
29. Hang up both telephones.
30. At the test telephone, pick up the receiver. Dial tone is heard.
31. Dial trunk access c o de. Dial tone is heard.
32. Dial the listed...

Test Telephones and Other Equipment
10-8Issue 1  September 1995  
49. Dial the listed directory number (LDN) for a working telephone. Ringback 
is heard through the earpiece of the test telephone.
50. At the called telephone, pick up the receiver. Conversation must be 
satisfactory.
51. Hang up both telephones.
Test the Attendant Console
Description
Check all lamps are operational and call another telephone in the system.
Procedure
1. Open front panel of console, press and hold Test or Self-Test switch....

Test the Selector Console
Issue 1  September 1995 
10-9
Test the Selector Console
Description
Check that all selector console lamps are o perational. Make call to a telephone in 
the system.
Procedure
1. O pen front panel of attendant console, press and hold Test or Self-Test 
switch.
2. Each row of lamps on the selector console lights and goes dark in 
sequence from to p to bottom.
3. Press hundreds group select button.
Hundreds group select lamp lights and any lamp s associated with busy 
telephone...