Apple studio display 15 lcd adc User Manual
Here you can view all the pages of manual Apple studio display 15 lcd adc User Manual. The Apple manuals for Display are available online for free. You can easily download all the documents as PDF.
Page 21
18 Studio Display 15” (ADC) Take Apart Hinge Procedure 1. Remove the four hinge screws. 2. Lift the hinge off the chassis.
Page 22
Studio Display 15” LCD (ADC) Take Apart - 19 ADC Cable ADC Cable Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield. • Remove the hinge.
Page 23
20 Studio Display 15” (ADC) Take Apart ADC Cable Procedure 1. Note: The hinge would already be removed. Disconnect the three ADC cables and remove three screws (one is located toward the bottom of the ADC cable). 2. Lift the ADC cable off the chassis.
Page 24
Studio Display 15” LCD (ADC) Take Apart - 21 Front Bezel Front Bezel Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat or soft cloth. Note: Plastics are easily damaged. The white gloves prevent fingerprints. • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield.
Page 25
22 Studio Display 15” (ADC) Take Apart Front Bezel Procedure 1. Lift the chassis and LCD panel off the front bezel.
Page 26
Studio Display 15” LCD (ADC) Take Apart - 23 Touch Switches Touch Switches Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield. • Remove the horizontal and vertical clips • Remove front bezel
Page 27
24 Studio Display 15” (ADC) Take Apart Touch Switches Procedure 1. Remove the screw on each touch switch.
Page 28
Studio Display 15” LCD (ADC) Take Apart - 25 Touch Switches2. Disconnect the touch switches from their cable connectors (two middle circles below). The touch switches rest on the rubber boots (two outer circles below); set them aside so you don’t lose them.
Page 29
26 Studio Display 15” (ADC) Take Apart LCD Display LCD Display Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield. • Remove the horizontal and vertical clips.
Page 30
Studio Display 15” LCD (ADC) Take Apart - 27 LCD Display Procedure 1. Remove four LCD screws. Replacement Note: If you are replacing the LCD panel, remove the square piece of gray tape (stuck on the panel between the touch switches) and stick it on the replacement panel. The tape is cosmetic and goes behind the Apple logo in the bezel. 2. Carefully turn the panel over. Disconnect the backlight bulb cables from the inverter board and the touch switch cables from the touch switch boards.