Apple studio display 15 lcd adc User Manual
Here you can view all the pages of manual Apple studio display 15 lcd adc User Manual. The Apple manuals for Display are available online for free. You can easily download all the documents as PDF.
Page 11
8 Studio Display 15” (ADC) Take Apart Rear Shield 3. Slide the shield toward the ADC (Apple Display Connector), unlatching the metal tabs (circled below). Note: When reinstalling the metal shield, make sure that the display cables don’t get pinched. 4. Lift the shield off the back of the display.
Page 12
Studio Display 15” LCD (ADC) Take Apart - 9 Clips, Horizontal and Vertical Clips, Horizontal and Vertical Tools • Plastic flat blade or similar tool to pry the clips off Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and inner rear cover. • Remove the rear shield.
Page 13
10 Studio Display 15” (ADC) Take Apart Clips, Horizontal and Vertical Procedure 1. With the plastic flatblade screwdriver, or nylon probe tool (922-5065) pry between the clip and metal chassis to remove the two horizontal and two vertical clips.
Page 14
Studio Display 15” LCD (ADC) Take Apart - 11 Main PCB Main PCB Tools • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield.
Page 15
12 Studio Display 15” (ADC) Take Apart Main PCB Procedure 1. Disconnect the connectors and then remove the four screws. Lift the main board from the chassis.
Page 16
Studio Display 15” LCD (ADC) Take Apart - 13 Inverter Inverter Tools • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield.
Page 17
14 Studio Display 15” (ADC) Take Apart Inverter Procedure 1. Disconnect three connectors and remove two screws. 2. Lift the inverter from the chassis.
Page 18
Studio Display 15” LCD (ADC) Take Apart - 15 USB Cable Assembly USB Cable Assembly Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield.
Page 19
16 Studio Display 15” (ADC) Take Apart USB Cable Assembly Procedure 1. Disconnect the USB connector on the main board and remove three screws. Lift the cable connector from the chassis.
Page 20
Studio Display 15” LCD (ADC) Take Apart - 17 Hinge Hinge Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat • Remove the foot assembly. • Remove the back cover and the inner rear cover. • Remove the rear shield.