Apple power mac g4 gigabit ethernet User Manual
Have a look at the manual Apple power mac g4 gigabit ethernet User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartHard Drive, IDE /ATA - 59 Hard Drive, IDE /ATA Before you begin, open the side access panel. Note: The Power Mac G4 supports a total of three internal hard drives. It can accommodate up to two Ultra ATA drives in drive bay 3, near the rear of the computer. ATA drives are not supported in drive bay 1 or 2. Note: You must assign a SCSI ID number to every additional hard drive and the number must not conflict
Take ApartHard Drive, IDE /ATA - 60 with the ID number already assigned to another drive. One factory-installed drive has ID 0; a second factory- installed drive has ID 1.
Take ApartHard Drive, IDE /ATA - 61 1. Disconnect the Ultra ATA hard drive data cable and the hard drive power cable (P3) from the hard drive.
Take ApartHard Drive, IDE /ATA - 62 2. Remove the hard drive carrier mounting screw. 3. Pull the drive carrier back and lift up at an angle to release the carrier tabs from the slots in the chassis. 4. Remove the carrier and drive from the computer.
Take ApartHard Drive, IDE /ATA - 63 5. If youÕre returning the drive to Apple, remove the screws that mount the hard drive to the carrier. 6. Lift the hard drive from the carrier. Note: Drives must be returned to Apple in Apple packaging, without cables or carriers. Failure to comply with this requirement may result in a packaging noncompliance charge. For more information, refer to the service parts database.
Take ApartHard Drive, IDE /ATA - 64 Replacement Note: To install two drives in the U-shaped carrier, install the first drive in the bottom of the carrier. Then place the second drive in the carrierÕs upper bay and attach screws through the sides of the carrier into the sides of the drive. Note that tightening screws on the left side of the carrier bends the arms of the carrier into the drive, holding it securely.
Take ApartHard Drive, IDE /ATA - 65 Replacement Note: When reconnecting a dual-drive ATA cable to drives installed in a U-shaped carrier, be sure to attach the end connector to the drive in the bottom of the carrier.
Take ApartHard Drive, Ultra2 LVD SCSI - 66 Hard Drive, Ultra2 LVD SCSI Before you begin, open the right side access panel. Note: This computer supports a total of three internal hard drives. If a unit has at least one internal Ultra2 LVD SCSI drive, an Ultra2 LVD SCSI PCI card, and a SCSI data cable, you can connect additional internal and external Ultra2 LVD SCSI devices. The unitÕs SCSI data cable supports three internal SCSI drives;
Take ApartHard Drive, Ultra2 LVD SCSI - 67 this cable has a built-in terminator so you donÕt need to add one. You can connect external Ultra2 LVD SCSI devices to the port on the rear of the computer. If the computer came with one Ultra2 LVD SCSI drive, itÕs installed in drive bay 1, near the front of the computer. If it came with two drives, the second one is installed in bay 2. If a third drive is installed, itÕs in bay 3. Usually the computer uses the drive in bay 1 to start up.
Take ApartHard Drive, Ultra2 LVD SCSI - 68 You must assign a SCSI ID number to every additional hard drive and the number must not conflict with the ID number already assigned to a drive on the SCSI chain. One factory-installed drive has ID 0; a second factory- installed drive has ID 1; a third drive has ID 2. The SCSI PCI card has ID 7.