Apple power mac g4 gigabit ethernet User Manual
Have a look at the manual Apple power mac g4 gigabit ethernet User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartFront Panel Board, PCI/AGP Graphics/Gigabit Ethernet/Digital Audio - 5. Push in and pry up on the three tiny metal tabs to release the front panel board from the front panel shield.
Take ApartAntenna - 1 4 0 Antenna Note: The antenna is routed through the chassis in two ways: under the logic board and through drive bay 1. Do not remove or replace the antenna if it is routed under the logic board. To replace this type of antenna, you must replace the entire chassis. Before you begin, remove the following: ¥ top front handle ¥ top panel ¥ carrier support plate (if
Take ApartAntenna - 1 4 1 the antenna cable is routed underneath it) ¥ CD-ROM drive carrier 1. Disconnect the antenna cable from the AirPort card (if installed). 2. Free the antenna cable from the cable clamp and the fan bracket.
Take ApartAntenna - 1 4 2 3. Using a jewelerÕs screw driver, remove the antenna mounting screws and lift the antenna and antenna cable out of the computer.
Take ApartTop Handles, Front and Rear - 143 Top Handles, Front and Rear No preliminary steps are required before you begin this procedure.
Take ApartTop Handles, Front and Rear - 144 1. Using a 2.5 mm Allen wrench, remove the two allen screws securing each handle. 2. Lift the handle from the computer.
Take ApartTop Handles, Front and Rear - 145 Replacement Note: When installing the top handles (front and rear) orient them so that the three tiny bumps on the handle are in the orientation shown in the photo. The handle wonÕt fit properly if itÕs turned upside down. The top front and top rear handles are interchangeable.
Take ApartTop Panel - 146 Top Panel Before you begin, remove the following: ¥ top front handle ¥ top rear handle
Take ApartTop Panel - 147 1. Slide the top panel back, towards the power supply, to unhook the tabs. 2. Lift the top panel from the chassis.
Take ApartSupports, Front and Rear - 148 Supports, Front and Rear Before you begin, place the computer on an ESD mat and turn the unit upside down. ±Warning: When the computer is upside down or the lower supports are removed, the computer can be unstable.