Apple power mac g4 fw 800 User Manual
Have a look at the manual Apple power mac g4 fw 800 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Power Mac G4 (Mirror/FW 800) Take Apart - 69 AirPort Card Procedure 1. Detach the coaxial antenna wire from the port on the end of the AirPort Card. 2. Pull the clear plastic tab on the AirPort Card to disconnect the card from the connector on the logic board.
70 - Power Mac G4 (Mirror/FW 800) Take Apart AirPort Card Note: If you are not replacing the AirPort Card, stow the antenna wire on the side of the PCI card guide, being careful not to bend or crimp the wire tightly. Warning: Handle the AirPort antenna with care. Due to the cable routing through the chassis panels, an AirPort antenna can be replaced only by ordering a new computer enclosure.
Power Mac G4 (Mirror/FW 800) Take Apart - 71 AirPort Extreme Card AirPort Extreme Card Note: This section applies to the Power Mac G4 (FW 800) computer only. If you are replacing the original AirPort Card— the larger card—go to the previous section. Tools No tools are required for this procedure. Part Location Preliminary Steps Before you begin, open the side access panel.
72 - Power Mac G4 (Mirror/FW 800) Take Apart AirPort Extreme Card Procedure 1. Detach the coaxial antenna wire from the port on the end of the AirPort Extreme Card. 2. Pull the clear plastic tab on the card to disconnect the card from the connector on the logic board.
Power Mac G4 (Mirror/FW 800) Take Apart - 73 AirPort Extreme CardNote: If you are not replacing the AirPort Extreme Card, stow the antenna wire on the side of the card guide, being careful not to bend or crimp the wire tightly. Warning: Handle the AirPort antenna with care. Due to the cable routing through the chassis panels, an AirPort antenna can be replaced only by ordering a new computer enclosure.
74 - Power Mac G4 (Mirror/FW 800) Take Apart Bluetooth Bluetooth Note: This section applies to the Power Mac G4 (FW 800) computer only. Tools No tools are required for this procedure. Part Location Preliminary Steps Before you begin, open the side access panel.
Power Mac G4 (Mirror/FW 800) Take Apart - 75 Bluetooth Procedure 1. Holding the edges of the bluetooth board, pull the board straight up to disconnect it from the logic board. 2. Turn over the board and pull the round connector off the board.
76 - Power Mac G4 (Mirror/FW 800) Take Apart Bluetooth Note: If you are not replacing Bluetooth, stow the antenna wire on the side of the PCI card guide, being careful not to bend or crimp the wire tightly.
Power Mac G4 (Mirror/FW 800) Take Apart - 77 Video Card Video Card Tools The only tool required for this procedure is a Phillips screwdriver. Part Location Preliminary Steps Before you begin, open the side access panel.
78 - Power Mac G4 (Mirror/FW 800) Take Apart Video Card Procedure 1. Using a Phillips screwdriver, remove the video card mounting screw. 2 . Gently hold back the clip on the video card connector to release the card. 3. Pull the card straight up, and remove it from the computer.