Apple power mac g4 digital audio User Manual
Have a look at the manual Apple power mac g4 digital audio User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
BasicsWarranty - 19 Canada Only Power Mac G4 computers are covered under the Apple One- Year Limited Warranty. The AppleCare Protecion Plan is also available for these products. Service providers are reimbursed for warranty and AppleCare Protection Plan repairs. For pricing information, refer to Service Price Pages.
Service Source K © 2002 Apple Computer, Inc. All rights reserved. Take Apart Power Mac G4 / Macintosh Server G4
Take ApartIdentifying Models of the Power Mac G4 - 1 General Identifying Models of the Power Mac G4 There are six models of Power Mac G4 computers: AGP Graphics, PCI Graphics, Gigabit Ethernet, Digital Audio, QuickSilver, and QuickSilver 2002. Power Mac G4 (QuickSilver and QuickSilver 2002) computers are easy to identify. Unlike other Power Mac G4 models, these models
Take ApartIdentifying Models of the Power Mac G4 - 2 have a silver-colored case. They also have a recessed speaker on the front panel. To identify the other Power Mac G4 models, check the I/ O panel at the back of the computer. The sound ports align horizontally in the lower half of the I/O panel on PCI Graphics models and vertically on AGP Graphics/ Gigabit Ethernet models. On Digital Audio models, the sound ports are in the upper half of the I/O panel. In addition, Digital Audio models include four
Take ApartIdentifying Models of the Power Mac G4 - 3 expansion slots, instead of three slots on PCI/AGP Graphics/Gigabit Ethernet models. To further distinguish Gigabit Ethernet models from AGP Graphics models, check the logic boards. AGP Graphics boards include an internal FireWire connector at J9; Gigabit Ethernet boards do not. Note: Except where indi- cated, the following proce- dures apply to all six models.
Take ApartTools - 4 Tools ¥ Flatblade screwdriver ¥ Phillips screwdriver ¥ Allen wrench (2.5 mm) to remove the power supply, side panels, top and rear handles, and front and rear supports ¥ JewelerÕs screwdriver to remove the I/O panel cover and antenna ¥ Needlenose pliers to remove the right and left side panels ¥ ESD mat
Take Apart Opening the Computer - 5 Procedures Opening the Computer No preliminary steps are required before you begin this procedure.
Take Apart Opening the Computer - 6 1. Lift the latch to unlock the right side access panel. Note: Make sure the security bar is in the unlock position. 2. Gently lower the side panel onto a clean, ESD- safe mat to avoid scratching the case. Lower the side panel until it lies flat.
Take ApartVideo Card - 7 Video Card Before you begin, do the following: ¥ Open the side access panel. ¥ Remove the external video cable. Note: The AGP video card is always installed in slot 1 (short slot). The DVD decoder module is used only in Power Mac G4 (PCI Graphics) computers.
Take ApartVideo Card - 8 1. Remove the video card mounting screw. 2. If a plastic clip sur- rounds the video card connector, gently p ull back the clipÕs tab to release the card. Then gently pull the card up, and remove it from the AGP slot. 3. Power Mac G4 (PCI Graphics): If you are replacing the DVD decoder module, pull it straight off the card.