Apple power mac g4 digital audio User Manual
Have a look at the manual Apple power mac g4 digital audio User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Take ApartHard Drive, Ultra2 LVD SCSI - 69 1. Disconnect the Ultra2 LVD SCSI cable from the Ultra2 LVD SCSI card.
Take ApartHard Drive, Ultra2 LVD SCSI - 70 2. Disconnect the SCSI hard drive power cable (P5). Caution: Pull the SCSI power cable straight out of the connector on the drive. Any up or down motion to the connector could damage the drive. Replacement Note: The power cables attach to drives as follows: P5 attaches to bay 1 P2 attaches to bay 2 P3 attaches to bay 3 3. Disconnect the Ultra2 LVD SCSI data cable from the hard drive.
Take ApartHard Drive, Ultra2 LVD SCSI - 71 4. Remove the hard drive carrier mounting screw. 5. Pull the drive carrier back and lift up at an angle to release the carrier tabs from the slots in the chassis. 6. Remove the carrier and drive from the computer.
Take ApartHard Drive, Ultra2 LVD SCSI - 72 7. If youÕre returning the drive to Apple, remove the SCSI data cable and terminator (black plastic housing) from the top of the drive. The cable and terminator are attached to the drive with double-stick foam tape.
Take ApartHard Drive, Ultra2 LVD SCSI - 73 8. If youÕre returning the drive to Apple, you must also remove the hard drive carrier. Remove the four screws from the carrier and lift out the drive. Note: Drives must be returned to Apple in Apple packaging, without cables or carriers. Failure to comply with this requirement may result in a packaging noncompliance charge. For more information, refer to the service parts database.
Take ApartHard Drive, Ultra2 LVD SCSI - 74 9. If youÕre replacing the thermal pad on the drive, remove the old pad and apply the new pad to the same area on the drive. Important: Before installing a new 36 GB Ultra2 LVD SCSI IBM drive, you must apply a thermal pad, part number 922-3863.
Take ApartUltra2 LVD SCSI Card - 75 Ultra2 LVD SCSI Card Before you begin, open the side access panel.
Take ApartUltra2 LVD SCSI Card - 76 1. Remove the Ultra2 LVD SCSI card mounting screw. 2. Disconnect the Ultra2 LVD SCSI cable from the PCI card. Note: Make sure no external cable is attached to the card. 3. Gently lift up on the Ultra2 LVD SCSI card to remove it from the PCI slot.
Take ApartCarrier Support Plate - 77 Carrier Support Plate Note: Perform this procedure only if you must replace the support plate or the cables below the plate. Before you begin, do the following: ¥ Open the side access panel. ¥ Remove the hard drive carrier in drive bay 1.
Take ApartCarrier Support Plate - 78 1. Remove the two support plate mounting screws from the bottom of the unit.