Apple ibook g4 14 early 2004 User Manual
Have a look at the manual Apple ibook g4 14 early 2004 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
iBook G4 (14-inch) Take Apart - 70 I/O Bezel Procedure 1. With the computer on a soft cloth, remove the two screws from the I/O bezel. 2. Remove the I/O bezel from the computer frame. Note: When reassembling the computer, make sure that the I/O bezel is level and fits over all ports.
71 - iBook G4 (14-inch) Take Apart I/O Bezel 3. Install the replacement I/O bezel, and reassemble and test the computer. Note: When installing the replacement I/O bezel, make sure the bezel shield and the mylar panel fits over the underside of the logic board, as shown below.
iBook G4 (14-inch) Take Apart - 72 RJ11 Modem Cable RJ11 Modem Cable Tools • Soft cloth • Black stick (or other nonconductive nylon or plastic tool) Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • AirPort Extreme Card • Memory card • Bottom case • Bottom shield • DC-in board • Top case • Top shield • I/O bezel
73 - iBook G4 (14-inch) Take Apart RJ11 Modem Cable Procedure 1. With the computer on a soft cloth, lift up the modem sleeve and disconnect the RJ11 modem cable from the modem board. 2. Guide the cable up through the metal channel. 3. While supporting the computer assembly, slide the modem port forward and off of the logic board. 4. Install the replacement RJ11 modem cable, and reassemble and test the computer.
iBook G4 (14-inch) Take Apart - 74 Hard Drive Hard Drive Tools • Soft cloth • #0 Phillips screwdriver • Black stick (or other nonconductive nylon or plastic tool) • Torx T8 screwdriver Note: To organize the screws you remove from the computer, use a tray with divided compartments (such as a plastic ice cube tray). Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • AirPort Extreme Card • Memory card • Bottom case
75 - iBook G4 (14-inch) Take Apart Hard Drive • Bottom shield • DC-in board • Top case • Top shield Procedure 1. With the computer on a soft cloth, note the location of the hard drive and how the ribbon cable is routed. 2. Tilt up the computer assembly and disconnect the hard drive cable from the underside of the logic board. 3.Important: To avoid pinching the cable, perform the remaining steps with the end of the cable hanging free over a table edge.
iBook G4 (14-inch) Take Apart - 76 Hard Drive4. Remove the four identical screws at the hard drive bracket. 5. From the bracket side, tilt up the hard drive, and hold it by the sides of the drive. Warning: Handle the hard drive at the sides only. Do not touch or press anywhere else on the drive.
77 - iBook G4 (14-inch) Take Apart Hard Drive 6. Route the end of the hard drive cable through the opening in the computer frame. 7. Disconnect the hard drive brackets (with grommets attached) by pulling them straight off the drive. Note: When reassembling the computer, transfer both brackets (including the grommets) to the replacement hard drive so the grommets fit over the screw heads.
iBook G4 (14-inch) Take Apart - 78 Hard Drive8. Warning: Handle the hard drive at the sides only. Do not touch or press anywhere else on the drive. Warning: If the ribbon cable connector is pulled out unevenly, some connector pins could become bent and damaged. Using even force, pull the looped handle to disconnect the ribbon cable from the connector on the end of the hard drive. 9. Remove the four black Torx T8 screws from the ends of the hard drive, and transfer the screws to the replacement drive. 10. Install the replacement hard drive, and reassemble and test the computer.
79 - iBook G4 (14-inch) Take Apart Modem: iBook G4 (14-inch) Modem: iBook G4 (14-inch) Tools • Soft cloth • #0 Phillips screwdriver • Black stick (or other nonconductive nylon or plastic tool) Part Location Preliminary Steps Before you begin, remove the following: • Battery • Keyboard and RAM shield • AirPort Extreme Card • Memory card • Bottom case • Bottom shield • DC-in board • Top case • Top shield