Home > Anschutz > Small Bore Rifle > Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual

Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual

Here you can view all the pages of manual Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual. The Anschutz manuals for Small Bore Rifle are available online for free. You can easily download all the documents as PDF.

Page 21

Cheek piece
16 
Removing the cheek piece
16.1 
Unfasten the clamping screw [x].
 
X
Remove the cheek piece [1] from the holder.
 
X
Fit in reverse order.
 
X
Adjusting the cheek piece
16.2 
The cheek piece can be tilted to various positions. The knurled screws 
[y] and the fixing screws [z] must be released to set to the various 
positions.
Unfasten the clamping screw [x].
 
X
Release the appropriate adjusting screw for the desired tilt position.
 
X
Tilt the cheek piece [1]  and retighten the...

Page 22

Always look out for any changes or damage that 
may occur to the rifle.
In the event of a change or damage, the rifle must 
immediately be taken to an authorised gunsmith or 
sent to ANSCHÜTZ for inspection.
CAUTIoN!
The rifle should be protected from dust, sand, moisture, 
heat and damaging influences.
NoTE!
To reduce the risk of breaking the stock during 
transport, ANSCHÜTZ recommends separating the 
barrelled  action from the stock, especially during 
air travel.
NoTE!
After each use of the rifle,...

Page 23

Maintenance intervals
17.3 
Pay attention to the instructions supplied with the 
cleaner.
No TE!
Before shooting Carefully remove any oil from the rifle.
 
y
The de-oiling of the rifle should be carried out at room temperature, \
as too many residues 
 
$
can be left in the barrel if it is very cold.
Fire around 10 shots to re-establish even shot performance (oil 
 
y
shots).
After shooting Allow the rifle to warm up to room temperature with the breech and 
 
y
the snow cover opened.
Carefully remove...

Page 24

Pull the cleaning wicks through the barrel in a dry condition a few 
 
y
times, until the final cleaning wick does not show any appreciable 
contamination.
Wipe the rifle (including the stock) with an oily rag.
 
y
Take the rifle to a dealer/gunsmith for inspection.
 
y
Trigger maintenance
17.4 
Dry the trigger and keep free from dust (the release latches have 
 
y
been greased with long-life grease by Anschütz).
To avoid gumming, adhesion or soiling of the trigger parts, never 
 
y
wash out the inner...

Page 25

Disposal
20 
The disposal of the rifle must be carried out and certified by a specialist 
dealer or gunsmith.
Miscellaneous
21 
Additional information is available on the Internet at  
www.anschuetz-sport.com.
News about this and other products can also be obtained by  
subscribing to the free-of-charge ANSCHÜTZ Newsletter on the internet.
The original group for your rifle at 50 m is affixed to the CD case.
www.anschuetz-sport.com
25     

Page 26

Warranty
22 
SERIAL-NO.:
DATE:
THIS ITEM WAS BOUGHT FROM:
Stamp and signature of dealer
After thorough testing of materials and nished parts, this 
item has passed a rigid nal inspection as well as proof 
testing or test shooting. If, despite these precautions, there 
is any failure due to defective materials or workmanship 
(except broken stocks and springs) within two years, the 
necessary  repairs  will  be  carried  out  without  charge, 
insofar as the item was evidently defective at the time of...
Start reading Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual

Related Manuals for Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual

All Anschutz manuals