Home
>
Anschutz
>
Small Bore Rifle
>
Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual
Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual
Here you can view all the pages of manual Anschutz Small Bore Rifle Biathlon Small Bore Target Rifle 64 R User Manual. The Anschutz manuals for Small Bore Rifle are available online for free. You can easily download all the documents as PDF.
Page 21
Cheek piece 16 Removing the cheek piece 16.1 Unfasten the clamping screw [x]. X Remove the cheek piece [1] from the holder. X Fit in reverse order. X Adjusting the cheek piece 16.2 The cheek piece can be tilted to various positions. The knurled screws [y] and the fixing screws [z] must be released to set to the various positions. Unfasten the clamping screw [x]. X Release the appropriate adjusting screw for the desired tilt position. X Tilt the cheek piece [1] and retighten the...
Page 22
Always look out for any changes or damage that may occur to the rifle. In the event of a change or damage, the rifle must immediately be taken to an authorised gunsmith or sent to ANSCHÜTZ for inspection. CAUTIoN! The rifle should be protected from dust, sand, moisture, heat and damaging influences. NoTE! To reduce the risk of breaking the stock during transport, ANSCHÜTZ recommends separating the barrelled action from the stock, especially during air travel. NoTE! After each use of the rifle,...
Page 23
Maintenance intervals 17.3 Pay attention to the instructions supplied with the cleaner. No TE! Before shooting Carefully remove any oil from the rifle. y The de-oiling of the rifle should be carried out at room temperature, \ as too many residues $ can be left in the barrel if it is very cold. Fire around 10 shots to re-establish even shot performance (oil y shots). After shooting Allow the rifle to warm up to room temperature with the breech and y the snow cover opened. Carefully remove...
Page 24
Pull the cleaning wicks through the barrel in a dry condition a few y times, until the final cleaning wick does not show any appreciable contamination. Wipe the rifle (including the stock) with an oily rag. y Take the rifle to a dealer/gunsmith for inspection. y Trigger maintenance 17.4 Dry the trigger and keep free from dust (the release latches have y been greased with long-life grease by Anschütz). To avoid gumming, adhesion or soiling of the trigger parts, never y wash out the inner...
Page 25
Disposal 20 The disposal of the rifle must be carried out and certified by a specialist dealer or gunsmith. Miscellaneous 21 Additional information is available on the Internet at www.anschuetz-sport.com. News about this and other products can also be obtained by subscribing to the free-of-charge ANSCHÜTZ Newsletter on the internet. The original group for your rifle at 50 m is affixed to the CD case. www.anschuetz-sport.com 25
Page 26
Warranty 22 SERIAL-NO.: DATE: THIS ITEM WAS BOUGHT FROM: Stamp and signature of dealer After thorough testing of materials and nished parts, this item has passed a rigid nal inspection as well as proof testing or test shooting. If, despite these precautions, there is any failure due to defective materials or workmanship (except broken stocks and springs) within two years, the necessary repairs will be carried out without charge, insofar as the item was evidently defective at the time of...