Aleratec 15 HDD Copy Cruiser HighSpeed WL User Guide
Have a look at the manual Aleratec 15 HDD Copy Cruiser HighSpeed WL User Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 61 Aleratec manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
USER GUIDE Aleratec 1:3 Bl\f-ra\By/D\bD/CD LightScribe D\fplica\Btor SA™ Part No. 260201 U
www.aleratec.com Copyright/Model Ident\Bification The content of this manual is for informational purposes only and is subject to change without notice. This manual is copyright with all rights reserved. Under copyright laws, this manual and the software described within may not be copied, except in the normal use of the product(s) described within or to make a backup copy. Copyright© 2011 Aleratec, Inc. 9851 Owensmouth Avenue Chatsworth, CA 91311 U.S.A. Aleratec® is a registered trademark, and 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA™ is a trademark of Aleratec, Inc Check o\ft Aleratec Online! • aleratec.com • facebook.com/Aleratec • twitter.com/Aleratec • youtube.com/Aleratec Please record the following information to help expedite any warranty claim: Model No. _________________________Serial No.________________________ Date Purchased _______________________________________________________ Place of Purchase _____________________________________________________
www.aleratec.com Radio/T\b Interferenc\Be Statement The equipment described in this guide emits radio frequency energy. If it is not installed in accordance with the manufacturer’s instructions, it may cause interference with radio or television reception. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency ener gy. If not installed and used in accordance with the instruction manual, this equipment may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be verified by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. • Connect the equipment to an electrical outlet on a circuit that is different from the circuit to which the receiver is connected. • Consult your dealer or an experienced radio/TV technician for help. This equipment has been certified to comply with the limits for a Class B computing device, pursuant to FCC Rules. In order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with non- approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is cautioned that changes and/or modifications made to this equipment, without the approval of manufacturer, could void the user’s authority to operate this equipment.
www.aleratec.com Safety Reg\flations WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to authorized personnel only. CAUTION As the laser beam in these 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA is harmful to the eyes, do not attempt to disassemble the cabinet. Refer servicing to authorized personnel only. The use of optical instruments with this product will increase eye hazard. This BD/DVD/CD Duplicator is classified as a CLASS 1 LASER PRODUCT. The CLASS 1 LASER PRODUCT label is located on top of the internal drive enclosure. CLASS 1 LASER PRODUCT LASER KLASSE 1 PRODUKT
www.aleratec.com Table of Contents Introd\fction ..................\B..................\B..................\B..................\B..................\B.........1 Product Features ...................................................................................................1 Key Items – 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA ..........................2 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA: LCD Front Panel .................3 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA: Removable Hard Disk Drive ....4 Preca\ftions ..................\B..................\B..................\B..................\B..................\B.........5 Before you start: ...................................................................................................5 Overview ..................\B..................\B..................\B..................\B..................\B..............7 Unpacking the Unit ..............................................................................................7 Connect the Cables and Apply Power ..................................................................7 LightScribe Software Installation ........................................................................8 Using the LightScribe Labeling Software ..........................................................13 Other Label Printing Related Options ................................................................15 Control Functions...............................................................................................16 Stand-Alone D\fplicat\Bor SA: T\ftorials ..................\B..................\B..................\B17 Making Disc-to-Disc Copies ..............................................................................17 Load Source Files onto the Hard Drive .............................................................22 Load Master Disc onto the Hard Drive ..............................................................24 Rename Existing Hard Drive Partition Name ....................................................28 Delete Existing Hard Drive Partition Permanently ............................................30 How to Make Copies from the Hard Drive ........................................................32 Select Burn Speed ..............................................................................................37 Select the Source drive .......................................................................................39 Change the SETUP Settings ..............................................................................41 Audio CD Editing ..............................................................................................42 Introduction to Manage Accounts .....................................................................50 Manage Accounts: Overview .............................................................................51 Introduction to Duplication Mode .....................................................................54 Using AUTOCOPY ............................................................................................57 Men\f Overview ..................\B..................\B..................\B..................\B..................\B.59 Tro\fbleshooting ..................\B..................\B..................\B..................\B.................66 Recommended Media ..................\B..................\B..................\B..................\B........70 Technical S\fpport ..................\B..................\B..................\B..................\B..............71 Service and S\fpport ..................\B..................\B..................\B..................\B...........73 Technical S\fpport FAX Back Form ..................\B..................\B..................\B.....75
www.aleratec.com1 Introd\fction Thank you for purchasing the 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA. Please read this User Guide thoroughly before using this product. Prod\fct Feat\fres The Aleratec 1:3 Blu-ray/DVD/CD LightScribe Duplicator SA is a stand alone LightScribe disc publishing system with the capability of simultaneously producing up to 3 BD/DVD/CD copies or 3 clearly labeled DVD/CD discs, and no computer is required. • Removable Hard Disk Drive to store disc images and label files.* • Aleratec only USB fast key instantly connects Hard Drive to a PC. • BD/DVD/CD source drive for fast on the fly copies. • Laser burns disc labels.* • Powerful Aleratec Disc Publishing Suite and LightScribe Labeling Software included. *Note: There is c\frrently no LightScribe Bl\f-ray media available.
www.aleratec.com2 Introd\fction Key Items – 1:3 Bl\f-\Bray/D\bD/CD LightScri\Bbe D\fplicator SA *Note: There is c\frrently no LightScribe Bl\f-ray media available. Control Panel Removable \fard Di\bc Drive(\bee page 4) BD/DVD/CD Source Drive BD/DVD/CD RW LightScribe Drive\b*
www.aleratec.com3 Introd\fction 1:3 Bl\f-ray/D\bD/CD Li\BghtScribe D\fplicator\B SA: LCD Front Pane\Bl (View may vary from picture) 1. Display shows all functions and messages 2. ESC button is used to cancel a selected function 3. ENT button is used to execute a selected function 4. COPY button will start the “Autocopy” menu function. (See page 59 for more information) 5. USB button will take you directly to the USB On/Off mode option. (See page 65 for more information) 6. PRINT button will take you directly to the print menu. 7. SOURCE button will allow you to change the Source drive that the duplicator uses for loading Master Discs. The default for this option is the BD/DVD/CD source drive. (See page 33 for more information) 8. UP arrow is used to scroll up through functions or menus 9. DOWN arrow is used to scroll down through functions or menus ESC Initialize D\fplicator1-3 ver: X.XX 8 13 9 2 ENT COPYUSBSOURCEPRINT 4567
www.aleratec.com4 Introd\fction 1:3 Bl\f-ray/D\bD/CD Li\BghtScribe D\fplicator\B SA: Removable Hard\B Disk Drive Your Duplicator SA is equipped with a removable hard disk drive (HDD) for storing images of frequently copied discs. Storing an image of a disc you want to copy on an HDD improves duplication speed, and adds the convenience of not having to look around for the actual source disc you want to copy. Your removable HDD provides extra security, in that you can remove the drive containing the disc images and put it in a safe place where no un-authorized users can copy or view the data. The removable HDD includes a keyed lock to protect the data on the drive from being misused or stolen. The HDD is used in the copy process as described in the following pages of this user guide. Note: You can u\be the dupl\bicator to copy dire\bctly from BD, DVD\b or\b CD\b with or without the \fDD. \bJu\bt place your \bou\brce di\bc in the BD/DVD\b/CD \bource drive or any of the\b BD/DVDRW writer\b. To remove the \fDD: 1. Unlock the HDD by inserting the key and turning it left (counterclockwise) 1/4 turn. The drive is now in the unlocked position. 2. Lift the HDD carriage lever upward and pull out. The HDD carriage will come out of the tower and a protective drive bay door will close. To replace the \fDD: 1. Align the HDD carriage with the door opening and push the drive carriage through the protective drive bay door until you feel the drive seat in its connector. 2. Push the HDD carriage lever down, then insert your key and turn it 1/4 turn to the right (clockwise). The HDD is now in its locked position. You can remove the key. Note: The \fDD will not wor\bk unle\b\b it i\b \becure\bd in po\bition with th\be carriage lever and locked w\bith the key. Do not unlock the\b \fDD during operation\b, a\b you will de\btroy any co\bpie\b you are making.\b Removable \fard Di\bk Drive Key in Lock Carriage Lever