Home > Albrecht > Communications receiver > Albrecht AE77H Programmable Hand-Held-Scanner Operating Guide

Albrecht AE77H Programmable Hand-Held-Scanner Operating Guide

Here you can view all the pages of manual Albrecht AE77H Programmable Hand-Held-Scanner Operating Guide. The Albrecht manuals for Communications receiver are available online for free. You can easily download all the documents as PDF.

Page 11

11
Restore a Locked Out Channel
1. Press .
Locking a Channel While ScanningIf the scanner keeps stopping on a
particular channel due to noise or too
frequent transmissions, you may want
to keep that channel from scanning.
1. Wait until the scanner stops at thechannel.
3. The scanner immediately resumes scanning because the locked out
channel is no longer in the scanning
sequence.
Lockout Tips•To quickly lockout a series of
channels, start with the lowest
number channel. For example, if you
are locking...

Page 12

12
Restore All Locked-out Channels
1. Press .
2. Press and hold  /L/O for abouttwo seconds.
You will hear two beeps when all the
channels have been restored.
Priority Scan
When priority scan is turned on, your
scanner checks the priority channel
every two seconds for activity. If a
signal is present on the priority
channel, your scanner monitors the
channel until the transmission ends,
then resumes normal scanning. You
can designate any of the 100 available
channels as your priority channel.
Changing the...

Page 13

132. Enter lower limit of the search band.
a) Enter the frequency number.
b) Then press  .
c) Then press  /LIMIT.
BAND
Searching
Band SearchThe  AE 77H   has  6 factory-
Preprogrammed Search Bands. You
can search any of these Bands to find
desired frequencies if you do not have
a Frequency Directory handy, or if new
stations have been added since the
Directory was published.
1. Press and hold  /LIMIT to enter the Band Search Mode. Then
the upper and lower limits of the
band currently selected are...

Page 14

14
3. Enter upper limit of the search band.
a) Enter the frequency number.
b) Then press  .
Direct SearchYou can search by using or when
you listen to a channel.
1. Press .
2. Select a channel a) Enter the channel number.
b) Then press  .
— OR —
Enter the frequency.
3. Press 
or to start seaching.
4. Press  /LIMIT at any time to stop the search on a frequency.
Press /LIMIT to resume
searching.
BAND
BAND
4. Either press or to begin your
search.
5. Press  /LIMIT at any time to stop the search on a...

Page 15

2. Press to move to the next higher
frequency
3. Press 
to move down to the
previous frequency.
15
Search Hold Feature1. Press  /LIMIT at anytime to stop the search.BAND
5. When search is stopped, you canpress or  to move up or down 1
frequency step. 
Note:The search continues toward
either the upper or lower search limit,
depending on which direction key (
or ) was pressed last.
4. Press /LIMIT to resume searching.BAND
Channel SkipIf a particular channel continues to
interrupt search scanning, it...

Page 16

16
1. Press  /MON/ CLR to store thedisplayed frequency in the
MONITOR MEMORY.
2. Either press or to begin your
search.
3. Press  /PROG and enter the channel number, then press  /PROG again.
STEP
STEP
Storing Search FrequenciesYou can quickly store any frequency
you find during search. 4. Press  /MON/ CLR and
number key to select the MONITOR
MEMORY.
— OR —
/MON/ CLR repeatedly.
5. Press  to store the frequency in the channel you selected.
Note:You can program 10 MONITOR
MEMORIES.
Repeat steps 2 through...

Page 17

17
Care and Maintenance
General Use•Turn the scanner off before
disconnecting the power or replacing
the batteries.
•Always write down the programmed
frequencies in the event of memory
loss.
•If memory is lost, simply reprogram
each channel.
The display shows 000.0000 in all
channels when there has been a
memory loss.
•Always press each button firmly until
you hear the entry tone for that key
entry.
Location•Do not use the scanner in high-
moisture environments such as the
kitchen or bathroom.
•Avoid...

Page 18

18
Troubleshooting
If your AE 77 H is not performing properl y, try the following steps.
Problem Suggestion
Scanner won ’t work. 1. Check the connections at both ends of the AC Adapter.
2. Turn on the wall switch of your room. You could be using an outlet controlled by the wall switch.
3. Check to see the batteries are installed followed by the  + and  – symbols.
Improper reception. 1. Check the antenna connection or move and reposition  the antenna.
2. Move the scanner.
3. You may be in a remote area...

Page 19

19
Specifications
Declaration of Conformity
Channels: 100
Frequency Bands (European version see annex on last page):No. RANGE (MHz) MODE STEP (kHz)
(1)  66.0000 -  88 .0000  FM   5
(2) 108.0000 - 136.9750 AM 12.5 or
(2) 108.0000 - 136.9916 AM 8.33
(3) 137.0000 - 143.9950 FM 5
(4) 144.0000 - 145.9875 FM 12.5
(5) 146.0000 - 174.0000 FM 5
(6) 406.0000 - 512.0000 FM 12.5
Operating temperature :– 20 °C to +60 °C
Scan rate:17 channels per second
Search rate:20 steps per second
Scan delay:2 seconds
Audio...

Page 20

 
 
 
 
 
 
 
 
CE Konformitätserklärung/ Declaration of Conformity 
 
 
 
Hiermit wird erklärt, daß unser Produkt / herewith we declare that\
 our product   
 
 
Empfangsgerät für Funkdienste (Scanner)  AE 77 H  
 
 
den folgenden europäischen Normen entspricht: / is in conformity  to following 
European Standards   
 
EU -Richtlinien / EU directives 73/23/EEC (LVD); 89/336 EEC  (EMC) and 99/5/EEC (R&TTE) 
EN 301 489-1,  EN 301 489-5, EN 301 489-15 (EMC) 
EN 300 086-2 (PMR Radio)
EN 301 783-2 (Amateur...
Start reading Albrecht AE77H Programmable Hand-Held-Scanner Operating Guide

Related Manuals for Albrecht AE77H Programmable Hand-Held-Scanner Operating Guide

All Albrecht manuals