Aiphone NIM Series Instructions User Manual

							31
APPENDIX
MOUNTING CONNECTION GETTING STARTED
SETUP AFTER 
INSTALLATION
Troubleshooting
If the system fails to operate normally, check the following points to determine whether the fault can be corrected by the simple 
measures suggested. If it cannot be corrected, or if the fault is not listed in the Symptom column, disconnect the power cord and 
contact the system supplier or service center for help. 
Symptom Cause Solution
The master station will not operate. The power switch on the back of the 
master station is in the OFF position.Turn on the power switch. (→ page 21)
The power of all the equipment is off.
No ringtone
No communication with sub station. Improper wiring connection
Verify the wiring 
# to #, M to M, and E 
to 
E between master and sub stations.
No communication to sub station. Improper wiring connection
Verify the wiring 
# to #, M to M, and E 
to 
E between master and sub stations.
An improper device is used for sub 
station.Verify a sub station compatible with the NIM 
system is used.
Call is not held. Improper wiring connection Verify connection of lead wires.
One way audio An improper device is used for sub 
station.Verify a sub station compatible with the NIM 
system is used.
#: Individual channel line (#: number)
M
: Common line (for microphone)
E
: Common line (for earth ground)
APPENDIX 
						

							AIPHONE CO., LTD., NAGOYA, JAPAN
http://www.aiphone.net/
Warranty
Aiphone warrants its products to be free from defects of material and workmanship under normal use and service for 
a period of one year after delivery to the ultimate user and will repair free of charge or replace at no charge, should it 
become defective upon which examination shall disclose to be defective and under warranty. Aiphone reserves unto 
itself the sole right to make the fi nal decision whether there is a defect in materials and/or workmanship; and whether or 
not the product is within the warranty. This warranty shall not apply to any Aiphone product which has been subject to 
misuse, neglect, accident, power surge, or to use in violation of instructions furnished, nor extended to units which have 
been repaired or altered outside of the factory. This warranty does not cover batteries or damage caused by batteries 
used in connection with the unit. This warranty covers bench repairs only, and any repairs must be made at the shop 
or place designated in writing by Aiphone. This warranty is limited to the standard specifi cations listed in the operation 
manual. This warranty does not cover any supplementary function of a third party product that is added by users or 
suppliers. Please note that any damage or other issues caused by failure of function or interconnection with Aiphone 
products is also not covered by this warranty. Aiphone will not be responsible for any costs incurred involving on site 
service calls. Aiphone will not provide compensation for any loss or damage incurred by the breakdown or malfunction of 
its products during use, or for any consequent inconvenience or losses that may result.
The object area of  is the EU.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may 
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause 
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This 
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
• 
Increase the separation between the equipment and receiver.• 
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• 
Consult the dealer or an experienced radio/TV technician for help.• 
IC
CAN ICES-3 (B)/NMB-3(B)
Issue Date: Feb. 2016
FK2242  A   P0216 SZ 57291