Home > AEM > Analog Performance Gauges > AEM Analog Oil Transmission Water Temperature SAE Gauge 305140 User Manual

AEM Analog Oil Transmission Water Temperature SAE Gauge 305140 User Manual

Add to Favourites
    Download as PDF

    View the AEM Analog Oil Transmission Water Temperature SAE Gauge 305140 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com Instruction Part Number: 10-5140 Rev 01  2010 AEM Performance Electronics Part Number 30-5140 Analog Style 100°F - 300°F Oil/Coolant/Trans Temperature Gauge NOTE: Faceplate Configuration Instructions Included on Separate Sheet Figure 1. Wiring Schematic AEM Oil/Coolant/Trans Temperature Gauge Parts 1 x 35-5140 Temperature Gauge Assembly...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16th” (52MM) mounting hole with the supplied bracket. 3. Plug the 8-wire power harness into the mating connector on the back of the gauge and connect the wires as shown in Figure 1. Note: the locating tabs on the side of the connector should be nearest the center of the gauge. 4. Thread the sensor into a suitable temperature port that has 1/8” NPT female threads. Note: a small amount of thread sealant...
    Page 3 Page 3 Changing the Bezel and Faceplate The gauge kit comes with the black bezel and black faceplate installed. However, the kit also comes with a silver bezel and multiple faceplates. Instructions on how to change the faceplate are included in the kit on a separate sheet of paper. To change the bezel, orient the gauge so you are looking at the faceplate. Rotate the bezel counter-clockwise to unscrew it from the gauge cup. The bezel, lens, and rubber spacer are all removable. Reassemble...
    Page 4 Page 4 Status Lights The AEM Temperature gauge has two status lights, see Figure 4. The status light on the left will turn on solid if the temperature is less than 100°F (40°C). The status light on the right will flash if the temperature exceeds 300°F (148°C). Both status lights will flash if the sensor is disconnected. The needle will point straight downward if the temperature exceeds 300°F (148°C) or the sensor is disconnected. See Table 1 for a description of the conditions....
    Start reading AEM Analog Oil Transmission Water Temperature SAE Gauge 305140 User Manual

    Related Manuals for AEM Analog Oil Transmission Water Temperature SAE Gauge 305140 User Manual

    All AEM manuals