Home > AEM > Analog Performance Gauges > AEM Analog Oil Fuel Metric Pressure Gauge 305133M User Manual

AEM Analog Oil Fuel Metric Pressure Gauge 305133M User Manual

Add to Favourites
    Download as PDF

    View the AEM Analog Oil Fuel Metric Pressure Gauge 305133M User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aemelectronics.com Instruction Part Number: 10-5133 Rev 02  2010 AEM Performance Electronics Part Number 30-5133 Analog Style 100 PSI Oil/Fuel/Air Pressure Gauge NOTE: Faceplate Configuration Instructions Included on Separate Sheet Figure 1. Wiring Schematic AEM Oil/Fuel Pressure Gauge Parts 1 x 35-5133 Pressure Gauge Assembly 1 x 30-2131-100 Pressure Sensor...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16th” (52MM) mounting hole with the supplied bracket. 3. Plug the 8-wire power harness into the mating connector on the back of the gauge and connect the wires as shown in Figure 1. Note: the locating tabs on the side of the connector should be nearest the center of the gauge. 4. Thread the sensor into a suitable pressure port that has 1/8” NPT female threads. Note: a small amount of thread sealant may...
    Page 3 Page 3 Changing the Bezel and Faceplate The gauge kit comes with the black bezel and black faceplate installed. However, the kit also comes with a silver bezel and multiple faceplates. Instructions on how to change the faceplate are included in the kit on a separate sheet of paper. To change the bezel, orient the gauge so you are looking at the faceplate. Rotate the bezel counter-clockwise to unscrew it from the gauge cup. The bezel, lens, and rubber spacer are all removable. Reassemble...
    Page 4 Page 4 Status Lights The AEM Pressure gauge has two status lights, see Figure 4. The status light on the left will flash if an out of range low voltage sensor error is detected. The status light on the right will flash if an out of range high voltage sensor error is detected. In either case, the needle will point straight downward to signify an error. See Table 1 for corrective actions. Status Light Fault Corrective Action Left Sensor Wiring and/or sensor Make sure sensor is...
    Start reading AEM Analog Oil Fuel Metric Pressure Gauge 305133M User Manual

    Related Manuals for AEM Analog Oil Fuel Metric Pressure Gauge 305133M User Manual

    All AEM manuals