Home > AEM > Analog Performance Gauges > AEM Analog Boost Metric Gauge 305132M User Manual

AEM Analog Boost Metric Gauge 305132M User Manual

Add to Favourites
    Download as PDF

    View the AEM Analog Boost Metric Gauge 305132M User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempower.com Instruction Part Number: 10-5132 Rev 04 © 2009 AEM Performance Electronics Part Number 30-5132 Analog Boost Gauge Figure 1. Wiring Schematic AEM Boost Gauge Parts 1 x 35-5132(B/W) Boost Gauge Assembly 1 x 30-2131-50 Boost Sensor 1 x 35-4302 Install Kit (6 Butt Connectors) 1 x 10-5132 Installation Instructions 1 x 35-3411 8-Pin Power...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16 th” (52MM) mounting hole with the supplied bracket. 3. Plug the 8-wire power harness into the mating connector on the back of the gauge and connect the wires as shown in Figure 1. Note: the locating tabs on the side of the connector should be nearest the center of the gauge. 4. Using the supplied hose adapter, boost tee, vacuum hose, and zip ties, connect the sensor to a good engine manifold...
    Page 3 Page 3 WHITE – The WHITE wire should be connected to the Analog + input on the AEM EMS or the analog + input on a similar device. BROWN – The BROWN wire should be connected to the Analog – input. If the EMS or similar device does not have a – input, the BROWN wire should be connected to a sensor ground. If no sensor ground is available, the BROWN wire should be connected to a power ground. Note: The BROWN wire must be connected in order to get correct readings from the analog output....
    Page 4 Page 4 Backlighting The AEM Boost Gauge has 7 different backlight colors available to the end user, which closely match some of the more common factory dash panels: white, blue, green, red, orange, light blue, and aqua. To change the backlight color, rotate the backlighting switch using a small precision style screwdriver. The backlight switch is accessed through the small hole in the back of the gauge. Status Lights The AEM Boost gauge has two status lights, see Figure 4. The...
    Start reading AEM Analog Boost Metric Gauge 305132M User Manual

    Related Manuals for AEM Analog Boost Metric Gauge 305132M User Manual

    All AEM manuals