AEG Steam oven BS836480KM User Manual

							Remove the grill- / roasting pan after the
end of the procedure.If the function: Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it out with a dry cloth. Let the appliance
dry fully with the door open.
12.8  Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate each time you switch off the appliance.
The soft reminder reminds and
recommends you to perform the
descaling cycle.
The hard reminder obligates you to perform the descaling.
If you do not descale the
appliance when the hard
reminder is on, you cannot
use the steam functions.
You cannot disable the
descaling reminder.12.9  Steam generation system
- Rinsing
Remove all accessories.
Select the function from the menu:
Cleaning. The user interface will guide
you through the procedure.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the baking tray on the first shelf
position.
2. Press 
.
3. Fill the water drawer with fresh water.
4. Press 
.
Remove the baking tray after the end of the procedure.
12.10  Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
6. Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
ENGLISH61     AA 1
2
B  
						

							9.Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, install
the glass panels and the door. Do the
above steps in the opposite sequence.
Install the smaller panel first, then the
larger.
12.11  Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The top lamp
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Remove the metal ring and clean the
glass cover.
3. Replace the lamp with a suitable 300
°C heat-resistant lamp.
4. Attach the metal ring to the glass
cover.
5. Install the glass cover.
The side lamp
1.Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.
4. Replace the lamp with a suitable 300
°C heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
13. 
TROUBLESHOOTINGWARNING!
Refer to Safety chapters.13.1  What to do if...ProblemPossible causeRemedyYou cannot activate or oper-
ate the oven.The oven is not connected
to an electrical supply or it is
connected incorrectly.Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).The oven does not heat up.The oven is deactivated.Activate the oven.The oven does not heat up.The clock is not set.Set the clock.The oven does not heat up.The necessary settings are
not set.Make sure that the settings
are correct.www.aeg.com62     
						

							ProblemPossible causeRemedyThe oven does not heat up.The automatic switch-off is
activated. Refer to "Automatic switch-
off". The oven does not heat up.The Child Lock is on.Refer to "Using the Child
Lock".The oven does not heat up.The door is not closed cor-
rectly.Fully close the door.The oven does not heat up.The fuse is blown.Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.The lamp does not operate.The lamp is defective.Replace the lamp.The display shows F111.The plug of the core tem-
perature sensor is not cor-
rectly installed into the sock-
et.Put the plug of the core tem-
perature sensor as far as
possible into the socket.The display shows an error
code that is not in this table. There is an electrical fault.• Deactivate the oven with the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the error code again, contact
the Customer Care De-
partment.Steam and condensation
settle on the food and in the
cavity of the oven.You left the dish in the oven
for too long.Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.The appliance does not re-
tain the water drawer after
you insert it.You did not assemble the lid
of the water drawer correct-
ly.Assemble the lid of the wa-
ter drawer correctly.Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.You did not assemble the lid
of the water drawer correct-
ly.Assemble the lid of the wa-
ter drawer correctly.Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.You did not assemble the
wave-breaker correctly.Assemble the wave-breaker
in the body of the water
drawer correctly.The appliance does not re-
tain the water drawer after
you push it on the cover.You did not fully press the
water drawer body.Insert the water drawer body
in the appliance by pushing
it until it reaches to the end.ENGLISH63 
						

							ProblemPossible causeRemedyThe water drawer is difficult
to clean.You did not remove the lid
and the wave-breaker.Refer to "Cleaning the water
drawer".The descaling procedure is
interrupted before it finishes.There was a power cut.Repeat the procedure.The descaling procedure is
interrupted before it finishes.The function was stopped by
the user.Repeat the procedure.There is no water inside the
grill- / roasting pan after the
descaling procedure.You did not fill the water
drawer to the maximum lev-
el.Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.There is dirty water on the
bottom of the cavity after
the descaling cycle.The grill- / roasting pan is on
a wrong shelf position.Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.The cleaning function is in-
terrupted before it finishes.There was a power cut.Repeat the procedure.The cleaning function is in-
terrupted before it finishes.The function was stopped by
the user.Repeat the procedure.There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.There is no good perform-
ance of the cleaning proce-
dure.The initial oven cavity tem-
perature of the steam clean-
ing function was too high.Repeat the cycle. Run the cy-
cle when the appliance is
cold.There is no good perform-
ance of the cleaning proce-
dure.You did not remove the side
grids before the start of the
cleaning procedure. They
can transfer heat to the walls
and decrease the perform-
ance.Remove the side grids from
the appliance and repeat the
function.There is no good perform-
ance of the cleaning proce-
dure.You did not remove the ac-
cessories from the appliance
before the start of the clean-
ing procedure. They can
compromise the steam cycle
and decrease the perform-
ance.Remove the accessories
from the appliance and re-
peat the function.www.aeg.com64 
						

							13.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate ison the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.We recommend that you write the data here:Model (MOD.).........................................Product number (PNC).........................................Serial number (S.N.).........................................14.  ENERGY EFFICIENCY14.1  Product Fiche and information according to EU 65-66/2014Supplier's nameAEGModel identificationBS836480KMEnergy Efficiency Index92.9Energy efficiency classAEnergy consumption with a standard load, conven-
tional mode0.93 kWh/cycleEnergy consumption with a standard load, fan-forced
mode0.79 kWh/cycleNumber of cavities1Heat sourceElectricityVolume71 lType of ovenBuilt-In OvenMass45.0 kgEN 60350-1 - Household electric cooking
appliances - Part 1: Ranges, ovens, steam
ovens and grills - Methods for measuring performance.14.2  Energy savingThe appliance contains
features which help you save
energy during everyday
cooking.General hints
Make sure that the oven door is closed
properly when the appliance operates
and keep it closed as much as possible
during the cooking.
Use metal dishes to improve energy
saving.
When possible, do not preheat the oven before you put the food inside.
When the cooking duration is longer
than 30 minutes, reduce the ovenENGLISH65  
						

							temperature to minimum 3 - 10 minutesbefore the end of the cooking time,
depending on the duration of the
cooking. The residual heat inside the
oven will continue to cook.
Use the residual heat to warm up other
dishes.Cooking with fan
When possible, use the cooking
functions with fan to save energy.
Residual heat
If a programme with the Duration or End
Time selection is activated and the
cooking time is longer than 30 minutes,
the heating elements deactivate
automatically 10% faster in some oven
functions.
The fan and lamp continue to operate.Keep food warm
Choose the lowest possible temperature setting to use residual heat and keep a
meal warm. The display shows the
residual heat indicator or temperature.
Cooking with the lamp off
Deactivate the lamp during cooking and
activate only when you need it.
15.  ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliancesmarked with the symbol  with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
www.aeg.com66   
						

							ENGLISH67 
						

							www.aeg.com/shop867302371-F-312016