AEG Sk 91240 5i Operating Instructions

							
51

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured
in accordance with the appropriate standards. The necessary measures
in accordance with appliance safety legislation regulations (GSG), acci-
dent prevention regulations for refrigeration appliances (VBG 20) and
the regulations of the German Society of Electrical Engineers (VDE)
were observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
This appliance is in accordance with the following EU guidelines:
Ð 73/23/EWG dated 19 February 1973 - low voltage guidelines.
Ð 89/336/EWG dated 3 May 1989 (including guideline change notice
92/31/EWG) - EMV guideline

Customer Service

If you cannot find the remedy for a malfunction in these operating
instructions, please contact your dealer or our customer service
department. Addresses and telephone numbers are listed in the accom-
panying booklet Guarantee Conditions/Customer Service Locations.
Selective ordering of replacement parts can save unnecessary travel
and costs. For this reason always provide the following appliance
information:
¥ Model Name
¥ Model Number (PNC)
¥ Serial Number (S-No.)
This information can be found on the serial plate in the interior at the\
left of the appliance. We recommend that you enter this information
here, so that it is handy if needed.

Note:
The customer bears the costs of unjustified customer service
calls even during the guarantee period.
 
						

							
52

Technical terminology

¥ Refrigerant

Liquids that can be used to a generate a cooling effect are known as
refrigerants. They have a relatively low boiling-point, indeed so low,
that the warmth from the food stored in the fridge or freezer can
cause the refrigerant to boil and vaporise.

¥ Refrigerant Circuit

Closed circulation system that contains the refrigerant. The refriger-
ant circuit comprises primarily of an evaporator, a compressor, a con-
denser and pipe work.

¥ Evaporator

The refrigerant is evaporated in the evaporator. Similar to all other
liquids, refrigerant requires heat to evaporate. This heat is removed
from the interior of the appliance, as a result the interior is cooled.
The evaporator is therefore located inside the appliance or placed in
foam immediately behind the inner wall and thus not visible.

¥ Compressor

The compressor looks like a small drum. It is driven by a built-in
electric motor and is mounted on the base of the appliance at the
rear. The task of the compressor is to draw in vaporised refrigerant
from the evaporator, to compress it, and to pass it on to the con-
denser.

¥ Condenser

The condenser normally has the form of a grid. The refrigerant com-
pressed in the compressor is liquefied in the condenser. During this
process, heat is released to the surrounding air at the surface of the
condenser. The condenser is mounted on the base of the appliance.
 
						

							
AEG HausgerŠte GmbH
Postfach 1036
D-90327 NŸrnberg
http://www.aeg.hausgeraete.de
© Copyright by AEG€nderungen vorbehalten
2222 652-65 -00- 082007 Subject to change without notice