AEG S 53600 Csw0 User Manual

Bananas, potatoes, onions and garlic, if
not packed, must not be kept in the re-
frigerator.
5.5 Hints for freezing
To help you make the most of the freez-
ing process, here are some important
hints:
• the maximum quantity of food which
can be frozen in 24 hrs. is shown on
the rating plate;
• the freezing process takes 24 hours.
No further food to be frozen should
be added during this period;
• only freeze top quality, fresh and thor-
oughly cleaned, foodstuffs;
• prepare food in small portions to ena-...

• regularly check the door seals and
wipe clean to ensure they are clean
and free from debris.
• rinse and dry thoroughly.
Do not pull, move or damage
any pipes and/or cables inside
the cabinet.
Never use detergents, abrasive
powders, highly perfumed clean-
ing products or wax polishes to
clean the interior as this will dam-
age the surface and leave a
strong odour.
Clean the condenser (black grill) and the
compressor at the back of the appliancewith a brush. This operation will improve
the performance...

• carefully scrape off the ice when it
starts to thaw. Use a wood or a plastic
scraper
• when all the ice has melted, clean and
wipe the cabinet dry, then put the
drainage channel back in place.
• switch on the cabinet and replace the
frozen foodstuff.
It is recommended to operate the ap-
pliance at the highest position of the
thermostatic control for some hours
so that it can reach the sufficient stor-
ing temperature as soon as possible.Never use sharp metal tools to
scrape off frost from the evapo-...

ProblemPossible causeSolution
 Products prevent that wa-
ter flows into the water
collector.Make sure that products
do not touch the rear
plate.
Water flows on the
ground.The melting water outlet
does not flow in the evap-
orative tray above the
compressor.Attach the melting water
outlet to the evaporative
tray.
There is too much
frost and ice.Products are not wrapped
properly.Wrap the products better.
 The door is not closed
correctly.Refer to "Closing the
door".
 The Temperature regula-
tor may...

ProblemPossible causeSolution
 The lamp is defective.Refer to "Replacing the
lamp".
If your appliance is still not working
properly after making the above checks,
contact the After Sales Centre.
7.1 Replacing the lamp
12
The appliance is equipped with a longlife
LED interior light.
1.Disconnect the appliance.
2.Push the movable part to unhook the
lamp cover (1).
3.Remove the lamp cover (2).
4.If needed replace the lamp with a
light of similar characteristic and pow-
er. It is suggested to use...

8.2 Location
AB
100 mm
min 20 mm
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the min-
imum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below over-
hanging wall units. Accurate...

8.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
8.6 Removing the shelf holders
A
B
C
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1.Move the shelf holders in the direc-
tion of the arrow (A).
2.Raise the shelf from the rear and
push it forward until it is freed (B).
3.Remove the retainers (C).
ENGLISH37
 

8.7 Door reversibility
E
F A
B
D C
WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the doors
of the appliance during the oper-
ations.
• Remove the spacer (A) and move to
the other side of the hinge pivot (B).
• Remove the doors.
• Remove the left-hand cover pin of the
middle hinge (C,D) and move to the
other side.
• Fit the pin of the middle hinge...

2
1
• Remove the plugs on the upper side
of both doors and move them to the
other side
• Re-insert the lower door on the lower
hinge pivot .
• Insert the middle hinge into the left
drill of the lower door.
• Unscrew the upper hinge pivot and
place it on the opposite side.
• Fit the upper door on the upper door
pivot.
• Re-insert the upper door on the mid-
dle hinge pivot slightly tilting both
doors.
• Re-screw the middle hinge . Do not
forget the plastic spacer .
A C B
• Remove the covers (B). Remove...

BRRR! HISSS!
CLICK!
BLUBB!
CRACK!
SSSRRR!
OK
CLICK!CLICK!
BRRR!
BRRR!
BLUBB!BLUBB!
40www.aeg.com