AEG B3101-5-m Manual

31 Cleaning and care
3.Fold up the  clamping levers (A) on both door 
hinges back into their original positions. 
4.Close the oven door.
Oven door glass
The oven door is fitted with three panels of glass mounted one behind the other.The in-
ner panels can be removed for cleaning.
1Important! Rough handling, especially around the edges of the front panel, can cause 
the glass to break.
Removing the door glass panels
1.Open the oven door as far as it will go. 
2.Undo the clamping levers (A) on both door...

Cleaning and care32
3.Close the oven door as far as the first position 
(approx. 45°). 
4.Take hold of the door trim (B) on the upper 
edge of the door at both sides and press in-
wards to release the clip seal. Then remove the 
door trim by pulling it upwards.
5.Take hold of the door glass panels on their up-
per edge one after the other and take them out 
of the guide by pulling them upwards.. 
Cleaning the door glass panels 
Clean the door glass panels thoroughly with a solution of water and washing...

33 Cleaning and care
2.Take hold of the door trim (B) at each side, po-
sition it on the inside edge of the door and plug 
the door trim (B) into the upper edge of the 
door 
3On the open side of the door trim (B) there is a 
guide bar (C). This must be pushedThis must be 
pushed between the outer door panel and the 
guide corner (D). 
The clip seal (E) must be snapped in.
3.Open the oven door as far as it will go  

What to do if …34
4.Fold up theclamping levers (A) on both door 
hinges back into their original positions 
5.Close the oven door.
What to do if…
 If you are unable to remedy the problem by following the above suggestions, 
please contact your local Service Force Centre.
1Warning! Repairs to the appliance are only to be carried out by qualified service engi-
neers. Considerable danger to the user may result from improper repairs. 
3If the appliance has been operated incorrectly, the engineers visit will...

35 Electrical Connection
Electrical Connection
The oven is designed to be connected to 230-240 V~(50Hz) electricity 
supply.
The oven has an easily accessible terminal block which is marked as 
follows:
1This oven must be earthed!
The cable used to connect the oven to the electrical supply must comply to the specifi-
cations given below.
For UK use only
It is necessary that you install a double pole switch between the oven and the electricity 
supply (mains), with a minimum gap of 3 mm 
between the...

Disposal36
Disposal
2Packaging material
The packaging materials are environmentally friendly and can be recycled. The plastic 
components are identified by markings, e.g. >PEPS

37 Installation Instructions
Installation Instructions
1Attention: The new appliance may only be installed and connected by a registered ex-
pert.
Please comply with this. If you do not, any damage resulting is not covered by the war-
ranty.
1Safety information for the installer
The electrical installation is to be set up so that the appliance can be isolated from the 
mains with a minimum 3mm all-pole contact separation.
Suitable separation devices include e.g. cut-outs, fuses (screw fuses are to be...

Installation Instructions38
 
  

39 Installation Instructions
 
 
  

Guarantee/Customer Service40
Guarantee/Customer Service
Standard guarantee conditions
We, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this 
AEG-Electrolux appliance or any part thereof is proved to be defective by reason only of 
faulty workmanship or materials, we will, at our option repair or replace the same FREE 
OF CHARGE for labour, materials or carriage on condition that:
The appliance has been correctly installed and used only on the electricity supply stat-
ed...