AEG Agn 71800 F0 User Manual
Have a look at the manual AEG Agn 71800 F0 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 513 AEG manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
ProblemPossible causeSolution Products are too near to each other.Store products so that there is cold air circulation. Upper or lower square is shown in the temperature dis- play.An error has occurred in measuring the tempera- ture.Call your service represen- tative (the cooling system will continue to keep food products cold, but temper- ature adjustment will not be possible). dEMo appears on the Display.The appliance is in dem- onstration mode (dEMo).Keep pressed approxi- mately 10 sec. the OK but- ton since a long sound of buzzer is heard and the Display shut off for a short while: appliance start works regularly. 6.1 Closing the door 1.Clean the door gaskets. 2.If necessary, adjust the door. Refer to "Installation". 3.If necessary, replace the defective door gaskets. Contact the Service Center. 7. INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and cor- rect operation of the appliance before installing the appliance. 7.1 Positioning WARNING! If you are discarding an old appli- ance that has a lock or catch on the door, you must ensure that it is made unusable to prevent young children being trapped in- side. The appliance shall have the plug accessible after installation. Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Cli- mate classAmbient temperature SN+10°C to + 32°C N+16°C to + 32°C ST+16°C to + 38°C T+16°C to + 43°C 7.2 Electrical connection Before plugging in, ensure that the volt- age and frequency shown on the rating plate correspond to your domestic pow- er supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the do- mestic power supply socket is not earth- ed, connect the appliance to a separate earth in compliance with current regula- tions, consulting a qualified electrician. The manufacturer declines all responsi- bility if the above safety precautions are not observed. ENGLISH11
This appliance complies with the E.E.C. Directives. 7.3 Door reversibility The door of the appliance opens to the right. If you want to open the door to theleft, follow these steps before you install the appliance: 1.Loosen and remove the upper pin. 2.Remove the door. 3.Remove the spacer. 4.With a key, loosen the lower pin. On the opposite side: 1.Tighten the lower pin. 2.Install the spacer. 3.Install the door. 4.Tighten the upper pin. 7.4 Ventilation requirements 5 cmmin. 200 cm2 min. 200 cm2 The airflow behind the appliance must be sufficient. 12www.aeg.com
7.5 Installing the appliance CAUTION! Make sure that the mains cable can move freely.Do the following steps: x x If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. Ø 2.5 mm 13 mm 1 32 Drill the appliance using a Ø 2.5 mm drill (10 mm max. penetration). Fix the square fitting to the appliance. ENGLISH13
1 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the op- posite side of the hinge. 44mm 4mm Adjust the appliance in the niche. Make sure that the distance between the appliance and the cupboard front-edge is 44 mm. The lower hinge cover (in the accessories bag) makes sure that the distance be- tween the appliance and the kitchen fur- niture is correct. Make sure that the clearance between the appliance and the cupboard is 4 mm. Open the door. Put the lower hinge cover in position. I I Attach the appliance to the niche with 4 screws. 14www.aeg.com
Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in op- posite case. EE B DC Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). ENGLISH15
21 mm ~50 mm~50 mm 90 o 90o 90o Install the part (Ha) on the inner side of the kitchen furniture. Ha Hc Push the part (Hc) on the part (Ha). Ha Hb 8 mm Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Remove the small squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied. 16www.aeg.com
Hb Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened.• The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. 8. NOISES There are some sounds during normal running (compressor, refrigerant circula- tion). BRRR!HISSS! CLICK! BLUBB! CRACK! SSSRR R! OK ENGLISH17
CLICK!CLICK!SSSRRR!SSSRRR! BRRR!BRRR!HISSS!HISSS! BLUBB!BLUBB!CRACK!CRACK! 18www.aeg.com
9. TECHNICAL DATA Dimension of the recess Height1780 mm Width560 mm Depth550 mm Rising Time 24 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronicappliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. ENGLISH19
INHALT 1.SICHERHEITSHINWEISE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 2.BEDIENFELD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 3.TÄGLICHER GEBRAUCH . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25 4.HILFREICHE HINWEISE UND TIPPS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 5.REINIGUNG UND PFLEGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 6.WAS TUN, WENN … . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 28 7.MONTAGE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 8.GERÄUSCHE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 9.TECHNISCHE DATEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 FÜR PERFEKTE ERGEBNISSE Danke, dass Sie sich für dieses AEG Produkt entschieden haben. Wir haben es geschaffen, damit Sie viele Jahre von seiner ausgezeichneten Leistung und den innovativen Technologien, die Ihnen das Leben erleichtern, profitieren können. Es ist mit Funktionen ausgestattet, die in gewöhnlichen Geräten nicht vorhanden sind. Nehmen Sie sich ein paar Minuten Zeit zum Lesen, um seine Vorzüge kennen zu lernen. Besuchen Sie uns auf unserer Website, um: Anwendungshinweise, Prospekte, Fehlerbehebungs- und Service-Informationen zu erhalten: www.aeg.com Ihr erworbenes Produkt zu registrieren, um den besten Service dafür zu gewährleisten: www.aeg.com/productregistration Zubehör, Verbrauchsmaterial und Original-Ersatzteile für Ihr Gerät zu erwerben: www.aeg.com/shop KUNDENDIENST UND -BETREUUNG Bitte verwenden Sie ausschließlich Original-Ersatzteile für Ihre Produkte. Halten Sie folgende Angaben bereit, wenn Sie sich an den Kundendienst wenden (diese Informationen finden Sie auf dem Typenschild): Modell, Produktnummer (PNC), Seriennummer. Warnungs-/ Sicherheitshinweise. Allgemeine Hinweise und Ratschläge Hinweise zum Umweltschutz Änderungen vorbehalten. 20www.aeg.com