ADT Security Services Simon 3 Owner Manual

	

CODE
EMERGENCY HOME CONTROL HOME SECURITY
Bypass
System
Status Doors &
WindowsMotion
Sensors
Arm
Disarm
9/0 5/6 3/4 7/8 1/2
On Off Sensor Motion Time Doors
Lights
Chim
e
AUX
Test Weekly
POLICE FIRE
User Guide
466-1871 Rev H
April 2003
Simon
®
 Security 
System
Part No:
60-875 

	


 

FCC Notices
FCC Part 15 Information to the User
Changes or modifications not expressly approved by Interlogix Inc. can void the user’s authority to operate the equipment.
FCC Part 15 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed 
to provide reasonable protection against interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy...

Canada Notice
The Canadian Department of Communications label identifies certified equipment. This certification means that the equipment meets certain telecommunica-
tions network protective, operational, and safety requirements. The department does not guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The 
equipment must also be installed...

Simon Security SystemContents 
  i
Contents
Introduction to Your Security System  1
Security System Components ............................................................................................................1
How You Communicate to Your System 2
Control Panel ......................................................................................................................................2
Remote Handheld Touchpad...

Simon Security SystemContents 
  ii 
Trouble Beeps 21
AC Power Failure ............................................................................................................................ 21
System Battery Failure  .................................................................................................................... 22
Sensor Failure  ................................................................................................................................. 22
Sensor Low...

Simon Security System1
Introduction to 
Your Security 
SystemYour security system uses wireless technology to warn your family about intrusion, car-
bon monoxide and fire. It may also be used to control lights and appliances within your 
home. The system has the capabilities of communicating with a central monitoring sta-
tion and sending messages to a numeric pager.
This manual describes how to operate your system. It will guide you through program-
ming instructions for system features as well as basic...

Simon Security System2
Outdoor Motion Sensors detect motion in a protected outdoor area. When motion is 
detected, the system may respond by sounding chimes or turning on outside lights. 
These sensors are not used for intrusion detection.
Door/Window Sensors detect the opening of a door or window. 
Smoke Sensors detect smoke and a significant rise in temperature. They have a built 
in siren that sounds when smoke or a significant rise in temperature is detected.
Freeze Sensors detect furnace failure. If...

Simon Security System3
How to Use 
Your Control 
Panel
The panel interface consists of four rows of buttons. 
Note  
It may be necessary to enter 
an access code to arm your 
system. Check with your 
installer to see if this feature 
is enabled. HOME SECURITY
CODE
 HOME CONTROL
EMERGENCY
HOME SECURITY
The Home Security buttons are used to arm and disarm doors, windows and motion sen-
sors in your system. The System Status button is used to give information on system 
activity.
Arm
Turn on...

Simon Security System4
Quick Exit 
Note  
The designated door may be 
opened and closed once. If 
you close the designated 
door behind you when you 
exit, you will have to disarm 
the system upon reentering. 
Leave the designated door 
open while using the Quick 
Exit feature.The Quick Exit feature is used when someone wants to briefly leave while the home is 
still armed (i.e. get the newspaper). This feature needs to be enabled by your installer. 
When you press the Disarm button the panel will...

Simon Security System5
Panel announces, Motions on, Latchkey on. Arm Motion Sensors light will blink and 
the exit delay will begin.


Disarming Your System
1. Upon reentering your home the entry delay will begin.
2. Status beeps will sound.
3. Enter your access code using the Code buttons.
Panel announces, System disarmed and the Disarm light will be lit.


Subdisarm Your System
1. Enter your Master Access Code while the system is disarmed.
Panel announces, System disarmed. Disarm button light blinks...