Home > Addonics Technologies > HDD/SSD/Optical Drive Enclosure > Addonics Technologies ZFamily enclosures ZSNESU3 User Manual

Addonics Technologies ZFamily enclosures ZSNESU3 User Manual

Add to Favourites
    Download as PDF Print this page Share this page

    Have a look at the manual Addonics Technologies ZFamily enclosures ZSNESU3 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 299 Addonics Technologies manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    View all the pages
    Page
    of 4
    Add page 1 to Favourites
    image text
    Enable zoom 
    							Technical Support
If you need any assistance to get your unit functioning properly, please have your 
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
T E C H N O L O G I E S
www.addonics.com
User Guide
Z Snap-In Mobile Rack(ZSNESU3)
    Add page 2 to Favourites
    image text
    Enable zoom 
    							www.addonics.comTechnical Support (M-F 8:30am - 6:00pm PST)    Phone: 408-453-6212  Email: www.addonics.com/support/query/
Unpacking and Installation:
Z Snap-In Mobile Rack Unit
Power SupplyeSATA cable
USB 3.0 Cable
    Add page 3 to Favourites
    image text
    Enable zoom 
    							www.addonics.comTechnical Support (M-F 8:30am - 6:00pm PST)    Phone: 408-453-6212  Email: www.addonics.com/support/query/
1. Be sure the lock on the drive door is in an unlock position. If 
not, use the key that came with the Raid Tower to unlock the 
drive door. Pull on the door lever to swing open the drive door all 
the way.
2. Slide a 3.5” SATA hard drive into the drive slot with the drive 
connector side facing in and the label side up. The drive should 
slide all the way into the slot with very little resistance. Forcing 
the drive into the slot will cause permanent damage to the drive 
or the Snap-In enclosure.
3. Once the drive is all the way into the drive slot, close the door 
all the way till the drive door latches securely. Lock the drive 
door with the key. This will engage power and data connection 
with the hard drive.
4. To remove the hard drive from the enclosure, simply follow the 
step 2 – 3 in reverse.
5. Connect the power supply to the unit.
6. Connect the eSATA or USB 3.0 cable from the back of the unit 
to the eSATA or USB port on the computer.
NOTE: When using the USB connection, be sure to disconnect 
the eSATA cable from the back of the unit.
7. Turn on the power switch on the back of the Z enclosure.
NOTE: When connecting the unit using eSATA, the computer must be turned 
off unless the eSATA port supports the hot swap feature. To determine 
whether or not your computers eSATA port supports hot swapping, refer to 
the computers user guide or its manufacturer.
    Add page 4 to Favourites
    image text
    Enable zoom 
    							www.addonics.com
Phone:   408-573-8580
Fax:     408-573-8588
Email:   http://www.addonics.com/sales/query/
CONTACT US
    All Addonics Technologies manuals Comments (0)

    Related Manuals for Addonics Technologies ZFamily enclosures ZSNESU3 User Manual