Acer Travelmate 800 Service Guide

Chapter 463
Use the following procedure as a guide for computer problems.
NOTE: The diagnostic tests are intended to test this model (TravelMate 800 series).  Non-Acer products, 
prototype cards, or modified options can give false errors and invalid system responses.
1.Obtain the failed symptoms in as much detail as possible.
2.Verify the symptoms by attempting to re-create the failure by running the diagnostic test or by repeating 
the same operation.
3.If any problem occurs, you can perform visual...

64Chapter 4
System Check Procedures
External Diskette Drive Check
Do the following steps to isolate the problem to a controller, driver, or diskette. A write-enabled, diagnostic 
diskette is required.
NOTE: Make sure that the diskette does not have more than one label attached to it. Multiple labels can cause 
damage to the drive or cause the drive to fail. 
Do the following to select the test device. See “System Diagnostic Diskette” on page 45 for details.
1.The FDD heads can become dirty over time,...

Chapter 465
Keyboard or Auxiliary Input Device Check
Remove the external keyboard if the internal keyboard is to be tested.
If the internal keyboard does not work or an unexpected character appears, make sure that the flexible cable 
extending from the keyboard is correctly seated in the connector on the main board.
If the keyboard cable connection is correct, run the Keyboard Test. See “System Diagnostic Diskette” on page 
45 for more details.
If the tests detect a keyboard problem, do the following one...

66Chapter 4
Check the Power Adapter
Unplug the power adapter cable from the computer and measure the output voltage at the plug of the power 
adapter cable. See the following figure
1.If the voltage is not correct, replace the power adapter.
2.If the voltage is within the range, do the following:
•Replace the main board.
•If the problem is not corrected, see “Undetermined Problems” on page 76.
•If the voltage is not correct, go to the next step.
NOTE: An audible noise from the power adapter does not...

Chapter 467
Check the Battery Pack
To check the battery pack, do the following:
From Software:
1.Check out the Power Options in control Panel
2.In Power Meter, confirm that if the parameters shown in the screen for Current Power Source and Total 
Battery Power Remaining are correct.
3.Repeat the steps 1 and 2, for both battery and adapter.
4.This helps you identify first the problem is on recharging or discharging.
From Hardware:
1.Power off the computer. 
2.Remove the battery pack and measure the...

68Chapter 4
still occurs, continue next step.
Replace the CPU with another of the same specifications. If the problems still occurs, go to next 
step.
The main board may be damaged. Replace main board.
3.If the external monitor has the same problem as the internal monitor,  the main board may be damaged. 
Please insert the diagnostic disk and run the display test program and go through the sub-steps under 
step 2.
Sound Check
To determine if the computer’s built-in speakers are functioning properly,...

Chapter 469
Power-On Self-Test (POST) Error Message
The POST error message index lists the error message and their possible causes. The most likely cause is 
listed first.
NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRU 
replacement does not solve the problem, put the original part back in the computer. Do not replace a 
non-defective FRU.
This index can also help you determine the next possible FRU to be replaced when servicing a computer.
If the...

70Chapter 4
Index of Error Messages 
Error Message List
Error MessagesFRU/Action in Sequence
0200 Failure Fixed Disk Hard disk error detected.
Check to see if fixed disk is attached properly.
Enter the BIOS Setup Utility and verify the hard disk is detected.
0211 Keyboard error see “Keyboard or Auxiliary Input Device Check” on page 65. 
0212 Keyboard Controller Failed see “Keyboard or Auxiliary Input Device Check” on page 65. 
May require replacing the keyboard controller.
0213Keyboard locked - Unlock...

Chapter 471
02F0 CPU ID CPU socket number for Multi-Processor error.
Main board
02F4 EISA CMOS not writeable System unable to write to EISA CMOS.
Main board
02F5 DMA Test Failed System unable to write to DMA (Direct Memory Access) registers.
Main board
02F6 Software NMI Failed System unable to generate software NMI (Non-Maskable Interrupt).
Main board
02F7 Fail-Safe Timer NMI Failed Fail-Safe Timer takes too long.
Main board
Invalid System Configuration Data Error with NVRAM (CMOS) data.
Enter the BIOS...

72Chapter 4
Index of Symptom-to-FRU Error Message
LCD-Related Symptoms
Symptom / ErrorAction in Sequence
LCD backlight doesnt work
LCD is too dark
LCD brightness cannot be adjusted
LCD contrast cannot be adjustedEnter BIOS Utility to execute “Load Setup Defaults” on Exit screen, 
then reboot system.
Reconnect the LCD connectors.
Keyboard (if contrast and brightness function key doesnt work).
LCD cable
LCD inverter
LCD
Main board
Unreadable LCD screen 
Missing pels in characters
Abnormal screen 
Wrong...