Acer Travelmate 6293 Service Guide

Chapter 243
13.Press “否”.
14.nsert Floppy with the Crisis disk on system. 

44Chapter 2
Crisis disk executing
1.Press Esc + Fn + Power all together at once, system will power on (for 1 second) then release all key 
pads.
2.When system power off, press Fn+ Esc and wait for system to power on again (about 4 seconds) .
3.Crisis disk executing, FDD should be reading for about 15 seconds.
4.System will power off on crisis disk executing completion.
5.Reboot system. 

Chapter 245
Trouble shooting
1.If Crisis disk is not working, please check the status of bios.wph file.
2.To fix incorrect bios.wph file format, please uncheck hide extensions for known file types. 

46Chapter 2
3.Rename it to bios.wph. 

Chapter 347
This chapter contains step-by-step procedures on how to disassemble the notebook computer 
TravelMate 6293 for maintenance and troubleshooting.
To disassemble the computer, you need the following tools:
‰Wrist grounding strap and conductive mat for preventing electrostatic discharge
‰Flat screwdriver
‰Small Philips screwdriver
‰Hex screwdriver
‰Plastic flat head screwdriver
‰Plastic tweezers
NOTE: The screws for the different components vary in size. During the disassembly process, group the...

48Chapter 3
General Information
Before You Begin
Before proceeding with the disassembly procedure, make sure that you do the following:
1.Turn off the power to the system and all peripherals.
2.Unplug the AC adapter and all power and signal cables from the system.  
3.Remove the battery pack.
Display screw list
No.SPECQuantityLocation
1 6052B0118301--M2x4.5(40Dx08T) 6 Display A&B Cover
2 6052B0127601--M2x4.0(40Dx08T) 7 Hinge / Inverter = 6 / 1
3 6052B0120001--M2x2.5(40Dx05T) 8 Panel / 3G Module /...

Chapter 349
Disassembly Procedure Flowchart
The flowchart on the succeeding page gives you a graphic representation on the entire disassembly sequence 
and instructs you on the components that need to be removed during servicing. For example, if you want to 
remove the system board, you must first remove the keyboard, then disassemble the inside assembly frame in 
that order.
Main unit disassembly flow chart 

50Chapter 3
LCM module disassembly flow chart 

Chapter 351
Removing the Battery Pack
1.Release the battery. 
2.Slide the battery latch then remove the battery.  

52Chapter 3
Removing the HDD/Wirless Card/RAM Module/ODD/Express 
Dummy Card/Card Reader Dummy Module
Removing CTO Cover
1.Loose 6 CTO cover screws.
2.Remove CTO cover.
Removing the HDD
3.Remove HDD module.