Acer Projector P1500 User Guide
Here you can view all the pages of manual Acer Projector P1500 User Guide. The Acer manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 51
41 English 3 Partial, scrolling or incorrectly displayed image (For notebooks)•Press RESYNC on the control panel or remote control. •For an incorrectly displayed image:•Follow the steps for item 2 (above) to adjust the resolution of your computer. •Press the toggle output settings. Example: [Fn]+[F4], Compaq [Fn]+[F4], Dell [Fn]+[F8], Gateway [Fn]+[F4], IBM [Fn]+[F7], HP [Fn]+[F4], NEC [Fn]+[F3], Toshiba [Fn]+[F5] •If you experience difficulty changing resolutions or your monitor freezes, restart...
Page 52
42 English Problems with the Projector 9 Image is too small or too large•Adjust the zoom lever on the top of the projector. •Move the projector closer to or further from the screen. •Press MENU on the control panel or remote control. Go to Image > Aspect Ratio and try different settings. 10 Image has slanted sides •If possible, reposition the projector so that it is centered on the screen and below the bottom of the screen. •Press the Keystone correction keys on the control panel or remote...
Page 53
43 EnglishOSD Messages # Condition Message Reminder 1 Message Fan Fail - the system fan is not working. Projector Overheated - the projector has exceeded its recommended operating temperature and must be allowed to cool down before it is used. Please also check the dust filters if they are installed. If the dust filter is clogged with dust, please clean it. Replace the lamp - the lamp is about to reach its maximum lifetime. Prepare to replace it soon. Fan Fail. Lamp will automatically turn off...
Page 54
44 English LED & Alarm Definition Listing LED Messages Message Power LED LAMP LED TEMP LED Red Blue Red Red Standby (Power cord plugged in)V-- -- -- Power on -- V -- -- Lamp retry -- Quick flashing-- -- Turning off (Cooling state)Quick flashing-- -- -- Turning off (Cooling completed)V-- -- -- Error (Thermal failure) -- V -- V Error (Fan lock failure) -- V -- Quick flashing Error (Lamp breakdown) -- V V -- Error (Color wheel failure)-- V Quick flashing--
Page 55
45 EnglishReplacing the Lamp Use a screwdriver to remove the screw(s) from the cover, and then pull out the lamp. The projector will detect the lamp life itself. It will show you a warning message Lamp is approaching the end of its useful life in full power operation. Replacement Suggested! When you see this message, change the lamp as soon as possible. Make sure the projector has been cooled down for at least 45 minutes before changing the lamp. Warning: Lamp compartment is hot! Allow it to cool...
Page 56
46 English Ceiling Mount Installation If you wish to install the projector using a ceiling mount, please refer to the steps below: 1 Drill four holes into a solid, structurally sound part of the ceiling, and secure the mount base. Note: Screws are not included. Please obtain the appropriate screws for your type of ceiling. 2 Secure the ceiling rod using the appropriate type of cylinder screws. 20 mm13mm 8.4mm130 mm 49.9mm Short Rod Screw Type A 50 mm length / 8 mm diameter -Ceiling Mount Base - Attach...
Page 57
47 English3 Use the appropriate number of screws for the projector size to attach the projector to the ceiling mount bracket. Note: It is recommended that you keep a reasonable space between the bracket and the projector to allow for proper heat distribution. Use two washers for extra support, if deemed necessary. 4 Attach the ceiling bracket to the ceiling rod. Smaller WasherLarge Washer Projector Bracket Supports projector and allows for adjustments Screw Type B Spacer - For heat dissipation...
Page 58
48 English 5 Adjust the angle and positioning as necessary. Note: The appropriate type of screw and washer for each model is listed in the table below. 3 mm diameter screws are enclosed in the screw pack. Models Screw Type B Washer Type Diameter (mm) Length (mm) Large Small X111/X1140/X1140A/ X111P/X1240/X1340W/ P1340W/X1340WH/ P1340WG/H6510BD/ P1500325VV 30 Allen KeyTightening Screw Allen Key Tightening Screw 110.05 mm 81.5 mm 55 mm
Page 59
49 EnglishSpecifications The specifications below are subject to change without notice. For final specs, please refer to Acers marketing documentation. Projection system DLP™ Resolution•X111/X1140/X1140A/X111P: Native: SVGA (800 x 600) Maximum: UXGA (1600 x 1200), 1080p (1920 x 1080) •X1240: Native: XGA (1024 x 768) Maximum: UXGA (1600 x 1200), 1080p (1920 x 1080) •X1340W/P1340W/X1340WH/P1340WG: Native: WXGA (1280 x 800) Maximum: UXGA (1600 x 1200), 1080p (1920 x 1080), WUXGA (1920 x 1200) (supports...
Page 60
50 English Throw ratio•X111/X1140/X1140A/X111P/X1240: 53±3% @ 2 m (1.86 - 2.04 : 1) •X1340W/P1340W/X1340WH/P1340WG: 63±3% @ 2 m (1.5 - 1.65 : 1) •H6510BD/P1500: 78.3±3% @ 2 m (1.15 - 1.5 : 1) Horizontal scan rate 31 - 99 KHz Vertical refresh scan rate 23 - 120 Hz Keystone correction +/-40 Degrees (Vertical), Manual & Auto Digital zoom 2 X Audio X1140A/X111P/X1240/X1340W/P1340W/X1340WH/ H6510BD/P1500: 2W x 1 Weight Approximate 2.0 kg (4.41 lbs.) Dimensions (W x D x H) 264 x 220 x 78.4 mm (10.4 x 8.7 x...