Acer Ferrari 1200 Service Guide
Here you can view all the pages of manual Acer Ferrari 1200 Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 111
Chapter 3101 9. Carefully pry open the LCD bezel and place the bezel on top of the LCD panel. 10.Disconnect the microphone cable and remove the bezel from the LCD panel.
Page 112
102Chapter 3 Removing the LCD module with the Brackets 1.See “Removing the Battery Pack” on page 64. 2.See “Removing the Lower Cover” on page 65. 3.See “Removing the WLAN Board Modules” on page 67. 4.See “Removing the Keyboard” on page 71. 5.See “Removing the Middle Cover” on page 72. 6.See “Removing the LCD Module” on page 74. 7.See “Removing the LCD Bezel” on page 100. 8.Disconnect the cable from the web camera.
Page 113
Chapter 3103 9.Remove the six screws (I) securing the LCD module. 10.Remove the LCD with the brackets from the back cover. Removing the FPC Cable 1.See “Removing the Battery Pack” on page 64. 2.See “Removing the Lower Cover” on page 65. 3.See “Removing the WLAN Board Modules” on page 67. 4.See “Removing the Keyboard” on page 71. 5.See “Removing the Middle Cover” on page 72. 6.See “Removing the LCD Module” on page 74. 7.See “Removing the LCD Bezel” on page 100. 8.See “Removing the LCD module with the...
Page 114
104Chapter 3 9.Disconnect the inverter board cable from its connector. 10.Detach the acetic tapes holding the FPC cable from the LCD panel and detach the acetic tape securing the FPC connector.
Page 115
Chapter 3105 11 .Disconnect the FPC cable from the LCD panel. Removing the LCD Brackets 1.See “Removing the Battery Pack” on page 64. 2.See “Removing the Lower Cover” on page 65. 3.See “Removing the WLAN Board Modules” on page 67. 4.See “Removing the Keyboard” on page 71. 5.See “Removing the Middle Cover” on page 72. 6.See “Removing the LCD Module” on page 74. 7.See “Removing the LCD Bezel” on page 100. 8.See “Removing the LCD module with the Brackets” on page 102. 9.See “Removing the FPC Cable” on page...
Page 116
106Chapter 3 10.Remove the four screws (J) securing the left and right LCD brackets to remove the brackets. Removing the Antennas 1.See “Removing the Battery Pack” on page 64. 2.See “Removing the Lower Cover” on page 65. 3.See “Removing the WLAN Board Modules” on page 67. 4.See “Removing the Keyboard” on page 71. 5.See “Removing the Middle Cover” on page 72. 6.See “Removing the LCD Module” on page 74. 7.See “Removing the LCD Bezel” on page 100. 8.See “Removing the LCD module with the Brackets” on page...
Page 117
Chapter 3107 10.Remove the tapes holding the antenna cables in place and release the cables from the latches. 11 .Remove the antenna cables from the back cover.
Page 118
108Chapter 3 Removing the Web Camera 1.See “Removing the Battery Pack” on page 64. 2.See “Removing the Lower Cover” on page 65. 3.See “Removing the WLAN Board Modules” on page 67. 4.See “Removing the Keyboard” on page 71. 5.See “Removing the Middle Cover” on page 72. 6.See “Removing the LCD Module” on page 74. 7.See “Removing the LCD Bezel” on page 100. 8.See “Removing the LCD module with the Brackets” on page 102. 9.Remove the Web camera from the back cover.
Page 119
Chapter 4109 Use the following procedure as a guide for computer problems. NOTE: The diagnostic tests are intended to test only Acer products. Non-Acer products, prototype cards, or modified options can give false errors and invalid system responses. 1.Obtain the failing symptoms in as much detail as possible. 2.Verify the symptoms by attempting to re-create the failure by running the diagnostic test or by repeating the same operation. 3.Use the following table with the verified symptom to determine...
Page 120
11 0Chapter 4 System Check Procedures External Diskette Drive Check Do the following to isolate the problem to a controller, driver, or diskette. A write-enabled, diagnostic diskette is required. NOTE: Make sure that the diskette does not have more than one label attached to it. Multiple labels can cause damage to the drive or cause the drive to fail. Do the following to select the test device. 1.Boot from the diagnostics diskette and start the diagnostics program. 2.See if FDD Test is passed as the...