Acer Aspire 8935g Service Guide

Chapter 3181
5.Push the LVDS cable onto the connector until it snaps into place.
6.Insert the LVDS cable into the cable channel all the way to the Hinge Well. Ensure that the cable passes under 
all retaining clips.
7.Insert the Antenna into the cable channel all the way from the Hinge Well. Ensure that the cables pass under 
all retaining clips. 

182Chapter 3
8.Push the Antenna cables through the Upper Cover as shown.
9.Turn the computer over pull the Antenna cables through to take up all slack from the upper cover side. 

Chapter 3183
Replacing the Power Board
1.Slide the Power Board under the retaining clip in the Switch Cover and set it in place, taking care to align the 
screw holes.
2.Insert the three screws to secure the Power Board to the Switch Cover.
1.Connect the FFC from the Power Board and close the locking latch.
StepSizeQuantityScrew Type
Power Board M2.5*4 3 

184Chapter 3
Removing the Switch Cover
1.Place the switch board face-down on top of the upper cover.
2.Connect the FFC to the Mainboard and close the locking latch.
3.Flip the Switch Cover into place and press down on the top edge until it snaps into place as shown.
4.Turn the computer over. Replace the thirteen screws to secure the Switch Cover to the Upper Cover. 

Chapter 3185
StepSizeQuantityScrew Type
Switch Cover
(red callout)M2.5*6.5 9
Switch Cover
(green callout)M2.5*4 4 

186Chapter 3
Replacing the Keyboard
1.Place the keyboard face down on the upper cover.
2.Connect the Keyboard cable by inserting the cable into the Mainboard and closing the locking latch. 

Chapter 3187
3.Connect the Backlight cable inserting the cable into the Mainboard and closing the FFC latch.
4.Flip the keyboard over and slide the bottom tabs into the holes in the upper cover.
5.Press the Keyboard into the Upper Cover until all the securing clips snap into place. 

188Chapter 3
External Module Reassembly Instructions
Replacing the WLAN Module 
1.Insert the WLAN board into the WLAN socket.2.Replace the single screw to secure the module.
3.Connect the two antenna cables to the module.
NOTE: The black antenna cable connects to the upper terminal and the white antenna cable to the lower 
terminal.
StepSizeQuantityScrew Type
WLAN Module M2*3 2 

Chapter 3189
Replacing the TV Tuner Module
1.Insert the TV Tuner as shown.
2.Connect the Antenna cable to the TV Tuner as shown.
NOTE:  When reattaching the Antenna, ensure the cable is tucked into the chassis to prevent damage.
3.Insert the single screw to secure the TV Tuner to the Mainboard.
StepSizeQuantityScrew Type
TV Tuner M2*3 1 

190Chapter 3
Replacing the DIMM Modules
Replacing the Hard Disk Drive Module
1.Insert the DIMM Module in place.2.Press down to lock the DIMM module in place.
1.Place the HDD in the HDD carrier.2.Replace the two screws to secure the carrier.
3.Insert the HDD, interface side first, and lower it into 
place.4.Slide the HDD in the direction of the arrow to 
connect the interface.