Acer Aspire 8935g Service Guide

Chapter 3171
Replacing the Media Board
1.Place the media board into the Upper Cover and press into place to secure the Media Board to the Upper 
Cover.
2.Replace the FFC into the Upper Cover by pressing the FFC onto the adhesive.
3.Connect the Media Board FFC to the Media Board and close the locking latch on the FFC. 

172Chapter 3
Replacing the Power Saving Board FFC
1.Insert the FFC into the slot in the Upper Cover as shown.
2.Press the FFC and adhesive protector onto the Upper Cover as shown. 

Chapter 3173
Replacing the Volume Control Board
1.Lift the board clear of the Upper Cover.
2.Replace the two screws to secure the board to the Upper Cover.
3.Connect the Volume Control FFC to the Volume Control Board and close the locking latch 
StepSizeQuantityScrew Type
Volume Control 
BoardM2*3 2 

174Chapter 3
4.Connect the Volume Control FFC to the Media Board and close the locking latch 

Chapter 3175
Replacing the Launch Board
1.Place the Launch Board into the Upper Cover, taking care to align the pins.
2.Connect the Mainboard FFC to the Launch Board and close the locking latch.
3.Press the FFC onto the adhesive on the Upper Cover to secure it in place and pass the FFC through the 
opening on the Upper Cover as indicated 

176Chapter 3
Replacing the Upper Case
1. Place the upper case on the lower case front edge first.
2.Insert the eleven screws to secure the upper cover to the lower cover.
StepSizeQuantityScrew Type
Upper Cover
(red callout)M2.5*4 10
Upper Cover
(green callout)M2*3 1 

Chapter 3177
3.Connect the following FFCs (A, B, D, and E) and cables (C, F, and G) to the Mainboard.
1.Connect the FFC to the Mainboard in position A and close the locking latch.
1.Connect the FFC to the Mainboard in position Band close the locking latch.
1.Connect the FFC to the Mainboard in position C and close the locking latch.
A
B
C
D
E 

178Chapter 3
1.Connect the FFC to the Mainboard in position D and close the locking latch.
1.Connect the FFC to the Mainboard in position E and close the locking latch. 

Chapter 3179
2.Turn the computer over. Replace the fifteen screws on the bottom panel.
 
Replacing the LCD Module
1.Using both hands, set the LCD Module into the Lower Cover, taking care to set the mounting pins into the 
bottom cover.
NOTE: Ensure that the antenna, microphone, and LVDS cables pass through the openings on the hinge wells 
before securing the LCD module in place.
StepSizeQuantityScrew Type
Upper Cover
(red callout)M2.5*6.5 9
Upper Cover
(green callout)M2.5*4 5
Upper Cover
(blue...

180Chapter 3
2.Insert the four screws to secure the LCD Module to the Lower Cover.
3.Connect the MIcrophone cable to the Mainboard.
4.Insert the Microphone cable into the cable channel all the way to the Hinge Well. 
StepSizeQuantityScrew Type
LCD Module M2.5*6.5 4