Acer Aspire 5737z Service Guide

Chapter 361
Removing the LCD Module
1.See “Removing the WLAN Module” on page 53.
2.See “Removing the Keyboard” on page 58.
3.Turn the computer over. Remove the two securing screws from the bottom of the chassis.
4.Remove the Antenna Cables from the cable channel as shown.
IMPORTANT:Ensure that the cables are free of all cable clips.
StepSizeQuantityScrew Type
LCD Module M2.5*8 2 

62Chapter 3
5.Turn the computer over and remove the adhesive tape securing the cables in place.
6.Remove the cables from the cable channel as shown.
7.Gently pull the cables through from the underside of the chassis. 
  

Chapter 363
8.Remove the cables from the remaining cable clips.
9.Disconnect the Microphone connector from the Mainboard and remove the cable from the channel.
10.Disconnect the LCD power connector from the Mainboard and remove the cable from the channel. 

64Chapter 3
11 .Once all the LCD cables are removed, the chassis appears as shown.
12.Remove the four securing screws (two each side) from the LCD module.
StepSizeQuantityScrew Type
LCD Module
(red callout)M2.5*8 2
LCD Module
(green callout)M2.5*6 2 

Chapter 365
13.Carefully remove the LCD module from the chassis.  

66Chapter 3
Removing the Upper Cover
1.See “Removing the LCD Module” on page 61.
2.Turn the computer over. Remove the nine screws on the bottom panel.
 
3.Turn the computer over. Disconnect the following three cables from the Mainboard.
StepSizeQuantityScrew Type
Upper Cover M2.5*8 9
AB
C 

Chapter 367
NOTE: Avoid pulling on cables directly to prevent damage to the connectors.
NOTE: Use the pull-tabs on FFC cables whenever available to prevent damage. 4.Disconnect A as shown.5.Disconnect B as shown.
6.Release the locking latch and remove the FFC cable as shown. 

68Chapter 3
7.Remove the twelve screws from the Upper Cover as shown.
8.Starting on the lower right side of the casing, pry the upper and lower covers apart as shown.
StepSizeQuantityScrew Type
Upper Cover
(red callout)M2.5*6 10
Upper Cover
(green callout)M2.5*3 2 

Chapter 369
9.Work along the casing toward the back and left, prying apart the casing.
10.Remove the Upper Cover as shown. 

70Chapter 3
Removing the TouchPad Bracket
NOTE: The TouchPad cannot removed from the Upper Cover. Replace the entire Upper Cover if the 
TouchPad malfunctions.
1.See “Removing the Upper Cover” on page 66.
2.Release the FFC locking latch and remove the TouchPad FFC from the chassis.
3.Remove the two screws from TouchPad bracket.
StepSizeQuantityScrew Type
TouchPad Bracket M2*3 2