Acer Aspire 2930 Service Guide
Have a look at the manual Acer Aspire 2930 Service Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 720 Acer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Chapter 3111 Replacing the Finger Print Reader NOTE: Carefully insert the FFC cable ends fully into the connector. Take care to line up the cable square with the connector before securing the FFC connector latch. Replacing the Upper Cover 1.Tilt the Upper cover and insert the left side of the cover into place. 2.Lower the casing into place and ensure that the I/O board FFC passes through the casing. 1.Replace the Finger Print Reader board in the upper cover. 2.Align the bracket and replace over the board.3.Replace the single securing screw.
11 2Chapter 3 3.Press down around the edges of the casing to snap it into place. 4.Connect the four cables to the mainboard as shown. A B C D
Chapter 311 3 5.Replace the five securing screws on the top panel. Insert the FFC flush with the connector and secure the latch as shown.Insert the FFC flush with the connector and secure the latch as shown. Insert the FFC flush with the connector and secure the latch as shown.Insert the FFC flush with the connector and secure the latch as shown.
11 4Chapter 3 6.Turn over the computer and replace the eight securing screws on the bottom panel. Replacing the LCD Module 1.Align the LCD Module hinges with the alignment pins and gently set down. 2.Connect the two cables as shown.
Chapter 311 5 3.Replace the ground screw cable and screw and replace the four securing screws on the hinges. 4. Secure the cables in place as shown. Ground Cable Ground Screw
11 6Chapter 3 5.Insert the Antenna Cables through the Upper Cover. Make sure they are accessible from the underside. 6.Turn the computer over and pull the antenna cables until they are taunt. 7.Place the antenna cables in the cable channel and insert them through the casing into the WLAN bay. 8.Replace the two securing screws on the bottom of the chassis.
Chapter 311 7 Replacing the Power Board Replacing the LED Board Replacing the Speaker Module 1.Place the Power Board in its location and replace the screw.2. Replace the FFC and ensure the cable is flush with the connector. Secure by locking the latch. 1.Place the LED Board in its location and replace the screw.2. Replace the FFC and ensure the cable is flush with the connector. Secure by locking the latch. 1.Replace both speaker modules as shown.
11 8Chapter 3 Replacing the Keyboard 2.Insert the cables flush with the connectors. 3.Replace the adhesive strip to secure the cabling.4.Replace the four securing screws. 1.Replace keyboard cable to the mainboard, and secure the locking latch.2. Turn the keyboard over and insert the bottom under the well guides on the upper cover.
Chapter 311 9 Replacing the Switch Cover Replacing the WLAN Module 1.Insert the bottom edge of the Switch Cover into the chassis.2. Press down along the length of the cover to snap it into place. 1.Insert the WLAN board into the WLAN socket. 2. Replace the two screws to secure the module. 3. Connect the three antenna cables to the module.
120Chapter 3 Replacing the Hard Disk Drive Module 1.Slide the HDD in the carrier as shown. 2. Replace the four screws (two on each side) securing the hard disk to the carrier. 3. Replace the HDD in the bay as shown. 4. Replace the three securing screws.