Acer Aspire 2930 Service Guide

Chapter 3111
Replacing the Finger Print Reader
NOTE: Carefully insert the FFC cable ends fully into the connector. Take care to line up the cable square with 
the connector before securing the FFC connector latch.
Replacing the Upper Cover
1.Tilt the Upper cover and insert the left side of the cover into place.
2.Lower the casing into place and ensure that the I/O board FFC passes through the casing. 1.Replace the Finger Print Reader board in the upper cover.
2.Align the bracket and replace over the...

11 2Chapter 3
3.Press down around the edges of the casing to snap it into place.
4.Connect the four cables to the mainboard as shown.
A
B
C
D 

Chapter 311 3
5.Replace the five securing screws on the top panel. Insert the FFC flush with the connector and secure 
the latch as shown.Insert the FFC flush with the connector and secure the 
latch as shown.
Insert the FFC flush with the connector and secure 
the latch as shown.Insert the FFC flush with the connector and secure the 
latch as shown. 

11 4Chapter 3
6.Turn over the computer and replace the eight securing screws on the bottom panel.
Replacing the LCD Module
1.Align the LCD Module hinges with the alignment pins and gently set down.
2.Connect the two cables as shown. 

Chapter 311 5
3.Replace the ground screw cable and screw and replace the four securing screws on the hinges.
4. Secure the cables in place as shown.
Ground Cable
Ground Screw 

11 6Chapter 3
5.Insert the Antenna Cables through the Upper Cover. Make sure they are accessible from the underside.
6.Turn the computer over and pull the antenna cables until they are taunt.
7.Place the antenna cables in the cable channel and insert them through the casing into the WLAN bay.
8.Replace the two securing screws on the bottom of the chassis. 

Chapter 311 7
Replacing the Power Board
Replacing the LED Board
Replacing the Speaker Module
1.Place the Power Board in its location and replace 
the screw.2. Replace the FFC and ensure the cable is flush with 
the connector. Secure by locking the latch.
1.Place the LED Board in its location and replace the 
screw.2. Replace the FFC and ensure the cable is flush with 
the connector. Secure by locking the latch.
1.Replace both speaker modules as shown. 

11 8Chapter 3
Replacing the Keyboard
2.Insert the cables flush with the connectors.
3.Replace the adhesive strip to secure the cabling.4.Replace the four securing screws.
1.Replace keyboard cable to the mainboard, and 
secure the locking latch.2. Turn the keyboard over and insert the bottom 
under the well guides on the upper cover. 

Chapter 311 9
Replacing the Switch Cover
Replacing the WLAN Module
1.Insert the bottom edge of the Switch Cover into the 
chassis.2.  Press down along the length of the cover to snap 
it into place.
1.Insert the WLAN board into the WLAN socket. 2. Replace the two screws to secure the module.
3. Connect the three antenna cables to the module. 

120Chapter 3
Replacing the Hard Disk Drive Module
1.Slide the HDD in the carrier as shown. 2. Replace the four screws (two on each side) 
securing the hard disk to the carrier.
3. Replace the HDD in the bay as shown. 4. Replace the three securing screws.