Acer Aspire 2930 Service Guide

Chapter 391
5.Disconnect the left and right Inverter board cables as shown. 

92Chapter 3
Removing the Camera Module
1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 88.
2.Remove the single securing screw.
IMPORTANT:Be careful when using a sharp tool to remove the cable or camera module. The surface of the 
LCD panel can be easily scratched.
3.Remove the bracket from the back cover.
StepSizeQuantityScrew Type
Camera Module M2.5*4 1 

Chapter 393
4.Lift the camera module as shown, but do not remove completely.
5.Hold the connector with one hand and pull the Camera Module to remove. 

94Chapter 3
Removing the LCD Panel
1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 88.
2.Remove the two securing screws from the LCD Module.
IMPORTANT:The correct screw sockets are indicated by a mark on the hinge.
3.Grasp the LCD Panel by the hinges and tilt upwards and away to remove the LCD Module.
StepSizeQuantityScrew Type
LCD Panel M2.5*4 2 

Chapter 395
Removing the LCD Brackets and FPC Cable
1.Remove the LCD Panel. See “Removing the LCD Panel” on page 94.
2.Turn the LCD panel over to expose the rear. Remove the mylar strips securing the FPC cable.
3.Grasp the pull-tab and disconnect the cable from the panel.
4.Remove the four securing screws (two on each side) from the LCD Panel brackets.
StepSizeQuantityScrew Type
LCD Brackets M2*4 4 

96Chapter 3
5.Remove the LCD brackets by pulling them away from the LCD Panel as shown.
Removing the LCD Antenna
1.Pull back the adhesive strips to expose the Antenna cables.
2.Pull up on the ends of the Antennas and remove the mylar strip from both Antennas. 

Chapter 397
Removing the LCD MIC
1.Remove the padding to expose the mylar cover.
2.Pull back the tabs to expose the MIC cable.
3.Grip the MIC cable and gently remove it from the back cover. 

98Chapter 3
LCD Module Reassembly Procedure
Replacing the LCD Panel
1.Insert the MIC cable along the mylar tabs as 
shown.2.Replace the tabs over the cable to secure in place.
3.Replace the padding over the mylar cover.4.Replace the mylar strip on both Antennas.
5.Replace both Antennas, take note of screw socket facing upwards. 

Chapter 399
6.Replace the eleven (11) adhesive strips to secure the Antenna cables.
7.Secure the top of the brackets in place and pivot the brackets towards the LCD Panel as shown.
8.Replace the four securing screws (two on each side) from the LCD Panel brackets. 

100Chapter 3
9. Connect the LCD cable to the panel.10.Replace the cable and press down attach the 
adhesive strips.
11 .Insert the top of LCD Panel first and tilt down in place.
IMPORTANT:Ensure all cabling is tucked correctly in the back cover.
12.Replace the two (2) securing screws on the LCD Module.
IMPORTANT:The correct screw sockets are indicated by the mark on the hinge.