Home > 3M > Projector > 3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide

3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide

Here you can view all the pages of manual 3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide. The 3M manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 51

46  © 3M 2008.  All Rights Reserved.

Appendices  3M™ Super Close Projection System  

Problem: Message Reminders
 Power Off:
 
  Replace the lamp:
    

Page 52

© 3M 2008.  All Rights Reserved.  47

3M™ Super Close Projection System Appendices

Replacing the Lamp
The projector keeps track of the lamp usage. It will show 
you a warning message:
When you see this message, change the lamp as soon as 
possible. Make sure the projector has cooled down for at 
least 30 minutes before changing the lamp. 
Lamp Replacement Procedure:
1. Turn off the power by pressing the Power/Standby button.
2.  Allow the projector to cool down for at least 30 minutes.
3.  Disconnect...

Page 53

48  © 3M 2008.  All Rights Reserved.

Appendices  3M™ Super Close Projection System  

Compatibility Modes
ModeResolution(ANALOG)(DIGITAL)
V.Frequency(Hz) H.Frequency(kHz) V.Frequency(Hz) H.Frequency(kHz) 
VGA640 x 3507031.57031.5
VGA640 x 3508537.98537.9
VGA640 x 4008537.98537.9
VGA640 x 4806031.56031.5
VGA640 x 4807237.97237.9
VGA640 x 4807537.57537.5
VGA640 x 4808543.38543.3
VGA720 x 4007031.57031.5
VGA720 x 4008537.98537.9
SVGA800 x 6005635.25635.2
SVGA800 x 6006037.96037.9
SVGA800 x...

Page 54

© 3M 2008.  All Rights Reserved.  49

3M™ Super Close Projection System Appendices

RS232 Protocol Function List
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Baud Rate : 9600    Data Bits: 8 Parity: None     Stop Bits: 1 Flow Control : None    UART16550 FIFO: Disable...

Page 55

50  © 3M 2008.  All Rights Reserved.

Appendices  3M™ Super Close Projection System  

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- SEND from projector automatically -----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------     when got...

Page 56

© 3M 2008.  All Rights Reserved.  51

3M™ Super Close Projection System Appendices

VGA-In Connector
Pin no.NameI/O (From Projector Side
1TXDOUT
2RXDIN
3GND—
Pin no.Spec.
1R(RED)/Cr
2G(GREEN)/Y
3B(BLUE)/Cb
4NC
5GND
6GND
7GND
8GND
9DDC 5V
10HOT–DET
11NC
12DDC Data
13HS/CS
14VS
15DDC Clock
123
10
45
6789
1112131415
12
3
RS232 Connector          

Page 57

52  © 3M 2008.  All Rights Reserved.

Appendices  3M™ Super Close Projection System  

Regulation & Safety notices
This appendix lists the general notices of your Projector. 
FCC notice 
This device has been tested and found to comply with the 
limits for a Class B digital device pursuant to Part 15 of the 
FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential instal-
lation. This device generates, uses, and can radiate radio 
frequency...

Page 58

© 3M 2008.  All Rights Reserved.  53

3M™ Super Close Projection System Appendices

Operation conditions 
This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions:
1.this device may not cause harmful interference, and
2. this device must accept any interference received, 
including interference that may cause undesired operation. 
Notice: Canadian users 
This Class B digital apparatus complies with Canadian 
ICES-003. 
Remarque à l’intention des...

Page 59

59
SERVICIO DIARIO: 
1.	 Revise	el	nivel	de	aceite	del	motor.
2.	 Revise	protector	de	la	hora	para	ver	si	hay	daño.
3.	 Revise	las 	mangueras 	y 	abrazaderas 	para 	ver 	si	
están dañadas o flojas. Apriete o reemplace según   
sea	necesario.
4.  Revise el INDICADOR DE RESTRICCIÓN del filtro 
de aire. Cambie el filtro de aire primario si el indicador 
está rojo.
5.	 Cerciórese 	de 	que 	todos 	los 	protectores 	de 	seguridad	
están	en	su	lugar	y	en	buenas	condiciones.
6.  Drene  el  agua  de  la  CAJA...

Page 60

60

CAJA  DE  ENGRANAJES  (3-2O)  (1,  2  ó  3)  y  el 
diámetro máximo de la hoja (pulgadas solamente). 
La velocidad de rotación (RPM, n/min) de la HOJA 
DE DIAMANTE (2E) debe permanecer en la banda 
de	color	apropiada	durante	la	operación.
ADVERTENCIA:  ¡Observe  la  posición 
d e l   I N T E R R U P T O R   S E L E C T O R   D E L 
TACÓMETRO  (1Z)!    El  tacómetro  puede 
indicar la velocidad de la hoja o la velocidad 
del motor. El operador o las personas del 
área  de  trabajo  pueden  sufrir...
Start reading 3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide

Related Manuals for 3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide

All 3M manuals