Zanussi Zwh 7120 P User Manual

Warning! The appliance is supplied with
a 13 amp plug attached. Use a 13 amp
ASTA approved (BS 1362) fuse if it is
necessary to change the fuse in the plugsupplied. A cut off plug inserted into a 13 amp
socket is a serious safety danger. Make sure
that it is disposed of safely.
First use
• Ensure that the electrical and water
connections comply with the installation
instructions.
• Ensure that the drum is empty.
• Before the first wash, run a cotton cycle
at the highest temperature without anylaundry in...

Before Loading The Laundry
Important! Make
sure that no metal
objects are left in the
laundry (e.g. hair
clips, safety pins,
pins). Button up pil-
lowcases, close zip
fasteners, hooks and
poppers. Tie any
belts or long tapes.
Remove any hooks
(e.g curtains).
• Never wash whites and coloureds together.
Whites may lose their «whiteness» in the
wash.
• New coloured items may run in the first
wash; they should therefore be washed sep-
arately the first time.
• Rub particularly soiled areas with a special...

Close the door gently
Warning! Make
sure that any
fabrics were not trap-
ped when closing the
door.
Detergents and additives
Good washing results also depend on the
choice of detergent and use of the correct
quantities to avoid waste and protect the envi-
ronment.
Although biodegradable, detergents contain
substances which, in large quantities, can up-
set the delicate balance of nature.
The choice of detergent will depend on the
type of fabric (delicates, woollens, cottons,
etc.), the colour, washing...

• Remove the drawer. Push the drawer edge
outwards where indicated by the arrow
(PUSH) to facilitate drawer removal.
The flap is down and you wish to use
powder detergent:
• Rotate the flap up-
wards. Ensure to fit
the flap completely
in.
• Carefully put the
drawer back.
• Measure out the
detergent.
• Pour the powder
detergent into the
main wash com-
partment 
 .
The flap is up and you wish to use liquid
detergent:
• Rotate the flap
downwards.
• Carefully put the
drawer back.
• Measure out the...

Set your washing programme
The control panel permits to select a washing programmes and different options.
When an option button is selected, the corresponding pilot light is on. Otherwise it is off.
For compatibility among washing programmes and options, see the "Washing Pro-
grammes". If an incorrect option is selected, the integrated red pilot light of the button 9
flashes 3 times and the display shows the message Err.
123456910
78
1Programme selector di-
al
Specials CottonsCottons
+Prewash...

2Temperature buttonPush the temperature button to select the most suita-
ble temperature for washing your laundry.
Cold: Cold wash.
3Spin reductionBy selecting a programme, the appliance proposes automati-
cally the maximum spin speed provided for that programme.
Press this button repeatedly to change the spin speed, if you
want your laundry to be spun at a different speed. The relevant
light illuminates.
4Rinse HoldBy pressing this button the corresponding pilot light illumi-
nates.
By selecting this...

7Display
7.1
7.2
7.3
The display shows the following information:
7.1 Delay Start icon
7.2 Child safety lock
This device permits you to leave the appliance unattended
during it's functioning.
7.3
•Duration of the selected programme
After selecting a programme, the duration is displayed in
hours and minutes (for example 
 ). The duration is cal-
culated automatically on the basis of the maximum recom-
mended load for each type of fabric. After the programme
has started, the time remaining is updated...

8Delay Start
Delay Start
The programme can be delayed from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a maximum of 20 hours
by means of this button.
Before you start the programme, if you wish to delay the start,
press this button to select the desired delay.
The selected delay time value will appear on the display for a
few seconds, then the duration of the programme will appear
again.
You must select this option after you have set the programme
and before you start the programme.
You...

9Start/ Pause
Start /Pause
Start the programme by pressing the button 9
• To start the selected programme, press the button 9, the
corresponding green pilot light stops flashing. The pilot light
10 illuminates to indicate that the appliance starts operating
and the door is locked. If you have chosen a delayed start,
the appliance will begin the countdown.
• To interrupt a programme which is running, press the but-
ton 9: the corresponding green pilot light starts flashing. It is
possible to change some...

the door open to prevent the formation of mil-
dew and unpleasant smells.
Warning! If there are children or pets in
the house, activate the child safety de-
vice in the inner side of the door frame (for
more details read " Child safety" in the chapter
"Safety Information").
Stand by : during programme setting up and
once the programme has finished, if the pro-
gramme selector dial and any button are not
touched, after a few minutes the energy saving
system is enabled. The pilot lights and...