Zanussi Zwg 6105 User Manual

50
Consumption values
Programme
duration 
(in minutes)Programme Energy
consumption 
(in kWh)Water
consumption 
(in litres)
125Cottons 95°C2.061
ZWG6105-ZWG 5125....155
ZWF6115 .......................125Cottons 60° Eco(*)ZWG6105-ZWG 5125...1.02
ZWF6115 ......................0.85ZWG6105-ZWG 5125......54
ZWF6115 .........................52
100Cottons 60°C - 40°C1.358
145Cottons 40°C Eco1.1454
55 Delicates 40º - Cold 0.5560
60Handwash 30º - Cold0.453
45Rinse0.142
10Spin--
2Drain--
80Synthetics 60º C -...

51
Installation instruction
Transit security bars
Before starting the machine up, the transport
security  bars must be removed as follows:
You are advised to keep all the transport
security bars. In case the appliance has to be
transported again.
1. Unscrew and remove the three rear screws
by means of a key.
2. Open the porthole and remove the
polystyrene block fitted with adhesive tape
on the door seal.
3. Place the machine in an upright position
and remove the three plastic bolts.
4. Plug the 3 holes...

52
Water inlet
There should be a COLD WATER tap near the
washing machine with a screwing on
connection pipe of 3/4" for the water supply, a
sink, a wash basin or a drainage system in the
wall.
Previously check if:
- it is not a hot water tap.
- the running water is clean. If not, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the
wall checked by a plumber.
1. Connect the hose to a tap with a 3/4”
thread. Always...

53
The drain hose may be extended to a
maximum of 4 metres. An additional drain
hose and joining piece is available from your
local Service Force Centre. The joining piece
must have an internal diameter of 18mm.
If your drain hose
looks like this (see
below) you do not
require the «U»
piece. Just push the
hose firmly into the
standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before,
remove any blanking plug that may be in
place.
Push the drain hose onto the spigot and
secure...

54
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
WARNING!
This appliance must be earthed.
The manufacturer declines any liability
should this safety measure not be
observed.
Before switching on, make sure the electricity
supply voltage is the same as that indicated
on the appliance’s rating plate. 
IMPORTANT!
Information on the electrical connection is
given on the rating plate on the inner edge
of the...

55
Environmental concerns
Packaging materials
The materials marked with the symbol  are
recyclable.
>PEPSPP

56
Guarantee conditions
Standard guarantee conditions
We, Electrolux, undertake that if within 12
months of the date of the purchase this
Electrolux appliance or any part thereof is
proved to be defective
by reason only of faulty workmanship or
materials, we will, at our option repair or
replace the same FREE OF CHARGE for
labour, materials or carriage on condition that:
●The appliance has been correctly installed
and used only on the electricity supply
stated on the rating plate.
●The appliance has been...

57
www.electrolux.com
126.2936.33…ZWF615.qxd  15/5/08  11:44  Página 57
 

126.2936.33
www.electrolux.com
126.2936.33…ZWF615.qxd  15/5/08  11:44  Página 60