Zanussi Zwf 1238 User Manual
Here you can view all the pages of manual Zanussi Zwf 1238 User Manual. The Zanussi manuals for Washing Machine are available online for free. You can easily download all the documents as PDF.
Page 21
After removing all the packaging, carefully lay machine on its back to re- move the polystyrene base from the bottom.Remove the power supply cable and the hoses from the hose holders on the rear of the appliance. Unscrew the three bolts.Slide out the relevant plas- tic spacers. Open the porthole and re- move the polystyrene block fitted on the door seal.Fill the smaller upper hole and the two large ones with the correspond- ing plastic plug caps sup- plied in the bag contain- ing the instruction book-...
Page 22
The other end of the inlet hose which connects to the appliance can be turned as showed in the picture. Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer...
Page 23
If the outlet spigot has not been used before, re- move any blanking plug that may be in place.Push the drain hose onto the spigot and secure with a clip, ensure a loop is formed in the drain hose (see above) to pre- vent waste from the sink entering the appliance. If you intend to drain the hose from the machine into a sink, make sure that the sink is empty and the plug hole is not blocked. Use the plastic “U - Piece” sup- plied. Special conditions If the floor is carpeted or covered with crumbly or...
Page 24
1 234 1Green & Yellow 2Brown 3Cord clamp 4Blue The wire coloured green and yellow must be connected to the terminal marked with the letter «E» or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the termi- nal «N» or coloured black. The wire coloured brown must be connected to the ter- minal marked «L» or coloured red. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. Warning! A...